Шуруповерты Hilti UH 700 2091317 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Recommended minimum conductor cross section and max. cable lengths
Conductor cross section
1.5 mm²
2 mm²
2.5 mm²
3.5 mm²
Mains voltage 100V
30 m
50 m
Mains voltage 110-120 V
30 m
50 m
Mains voltage 220-240 V
90 m
140 m
Do not use extension cords with 1.25 mm² conductor cross section.
2.9 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this application.
2.10 Using a generator or transformer
This power tool may be powered by a generator or transformer when the following conditions are fulfilled: The unit
must provide a power output in watts of at least twice the value printed on the type identification plate on the power
tool. The operating voltage must remain within +5% and -15% of the rated voltage at all times, frequency must be in
the 50 – 60 Hz range and never above 65 Hz, and the unit must be equipped with automatic voltage regulation and
starting boost.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching other
power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in damage to the
power tool.
3 Accessories
The list of insert tools can be found in Section 2 under “Possible applications”.
Designation
Short designation
Item number, description
Keyless chuck
274077
Key chuck
274079
Chuck key (with keyed chuck)
274081
Dust removal system
TE DRS‑S
340602
4 Technical data
Right of technical changes reserved.
Rated
voltage
100 V
110 V
120 V
220 V
230 V
240 V
Rated power
input
710 W
710 W
710 W
710 W
710 W
Rated current
input
7.5 A
6.9 A
8 A
3.5 A
3.1 A
3.1 A
Power tool
UH 700
Mains frequency
50…60 Hz
Weight of tool without side handle
2.4 kg
Weight in accordance with EPTA procedure 01/2003
2.6 kg
Dimensions (L x W x H)
342 mm x 86 mm x 205 mm
Speed in 1st gear under no load
900/min
Speed in 2nd gear under no load
2,500/min
Hammering speed
40,000/min
en
17
Printed: 03.12.2015 | Doc-Nr: PUB / 5071288 / 000 / 02
