Bosch PWS 8 125 CE - Инструкция по эксплуатации - Страница 15

English - 3

■

Hold the power tool only by the insulated
gripping surfaces, when performing an op-
eration where the cutting tool may run into
hidden wiring or its own cord.
Contact with a “live” wire will make exposed
metal parts of the tool “live” and shock the op-
erator.

■

Use appropriate detectors to determine if
utility lines are hidden in the work area or
call the local utility company for assist-
ance.
Contact with electric lines can lead to fire and
electric shock. Damaging a gas line can lead
to explosion. Penetrating a water line causes
property damage or may cause an electric
shock.

■

For work with grinding or cutting discs, the pro-
tection guard 6 must be mounted. For work
with the rubber sanding pad 13 or with the cup
brush 16 / disc brush / flap disc, mounting the
hand guard 12 (accessory) is recommended.

■

Use dust extraction when working with stone.
The vacuum cleaner must be approved for ma-
sonry dust. When cutting stone, use the cutting
guide.

■

Do not work with materials containing asbes-
tos.

■

Use only grinding tools with a permissible
speed at least as high as the no-load speed of
the machine.

■

Check grinding tools before use. The grinding
tool must be properly mounted and turn freely.
Perform a test run for at least 30  seconds with-
out load. Do not use damaged, out-of-round or
vibrating grinding tools.

■

Protect the grinding tool from impact, shock
and grease.

■

Apply the machine to the workpiece only when
switched on.

■

Keep hands away from rotating grinding tools.

■

Pay attention to the direction of rotation. Al-
ways hold the machine so that sparks and
grinding dust fly away from the body.

■

When grinding metal, flying sparks are pro-
duced. Take care that no persons are endan-
gered. Due to danger of fire, no combustible
materials should be located in the vicinity
(spark flight zone).

■

Be careful when cutting grooves, e.  g. in struc-
tural walls: See Information on Structures.

■

Blocking the cutting disc leads to jerking reac-
tion forces on the machine. In this case switch
off the machine immediately.

■

Observe the dimensions of the grinding discs.
The hole diameter must fit mounting
flange 8 (M 14), 19 (M 10). Do not use any re-
ducers or adapters.

■

Never use cutting discs for rough grinding. Do
not exert any lateral pressure on the cutting
discs.

■

Observe the manufacturer’s instructions for
mounting and using grinding tools.

■

Caution! The grinding tool runs on after the
machine is switched off.

■

Do not clamp the machine in a vice.

■

Never allow children to use the machine.

■

Bosch is only able to ensure perfect operation
of the machine if the original accessories in-
tended for it are used.

Slots in structural walls are subject to the Stand-
ard DIN 1053, Part 1 or country-specific regula-
tions.

These regulations are to be observed under all
circumstances. Before beginning work, consult
the responsible structural engineer, architects or
the construction supervisor.

Information on Structures

16 • 1 609 929 F32 • 03.06