IPC Portotecnica ATOMAX-C D 1813 P 40964 IDAF - Инструкция по эксплуатации - Страница 25

English

- 25 -

TABLE OF ROUTINE MAINTENANCE TO BE PER-

FORMED BY THE USER.

Description of operations:

Check power cable - pipes - high pressure

connectors

Ist oil change in H.P. pump

Subsequent changes in H.P. pump

Clean water filter

TABLE  OF  EXTRAORDINARY  MAINTENANCE TO  

BE  PERFORMED  BY  THE TECHNICAL SERVICE 

CENTRE

.

Description of operations:

Change seals on H.P. pump

Change lanze nozzle

Calibrate and check the safety devices

IMPORTANT:

These intervals refer to normal working conditions. For heavy duty use decrease the interval for each job.

For maintenance and/or repairs, use only original spare parts which offer the greatest characteristics of quality and 

reliability.  Failure to use original spare parts absolves the manufacturer from all liability and transfers it to the per

-

son carrying out the operation.

PERIODS OF INACTIVITY

If the machine is to remain inactive for a long period, disconnect the supply sources, drain the tank(s) of all the operating fluids 

and protect any parts that could be damaged by the accumulation of dust.

Grease the parts that could be damaged by drying out, such as the supply hoses.  When bringing back into use, ensure that 

there are no cracks or cuts in the water supply hoses.

Oil and chemical products must be disposed of according to current legislation.

SCRAPPING

If you no longer wish to use the water cleaner, you should render it unusable by removing the power cable. 

You should also make sure that all potentially hazardous parts of the appliance are made safe, particularly for children who could 

play with the unused water cleaner. 

This  product  is  classified  as  WEEE  type  special  waste  and  is  covered  by  the  requisites  of  the  new  environmental  protection 

regulations. It must be disposed of separately from ordinary waste in compliance with current legislation and standards.

Do not use parts dismantled for scrap as spare parts.

Every 500 hours

Every 200 hours

Once a year

Each use

After 50 hours

Every 500 hours

Every 50 hours

CHANGING THE HIGH PRESSURE NOZZLE

Information

The high pressure nozzle fitted on the lance must be changed 

from time to time, as this component is subject to normal wear 

during use.  Wear may generally be detected by a drop in the 

working pressure of the cleaner.  To replace it, consult your 

supplier and/or dealer for instructions.