IPC Portotecnica ATOMAX-C D 1813 P 40964 IDAF - Инструкция по эксплуатации - Страница 23

English

- 23 -

REGULATING PRESSURE 

This chapter concerns only 

t h o s e   m o d e l s   p r o v i d e d 

with  the  “pressure  regula

-

ting” device.

 The pressure 

regulator,  fig.  13,  allows  the 

operator to adjust the working 

pressure.  When knob C is 

turned in an anti-clockwise 

direction (B) (minimum), the 

working pressure is reduced.

ADVICE ON USING DETERGENTS

Warning

This cleaner has been designed for use with the detergents 

supplied or recommended by the manufacturer.

The  use  of  other  detergents  or  chemicals  may  influence  the 

safety of the cleaner.

1

) For environmental compatibility, we recommend a reaso-

nable use of detergents, according to the instructions on the 

pack.

2

) From the range of recommended products, choose the 

one most suited to the washing job to be done and dilute it 

with water according to the instructions on the pack or in the 

catalogue of the detergents most suited for the type of hot or 

cold water cleaner.

3

) Ask your dealer for the detergents catalogue.

OPERATING PHASES FOR CORRECT CLEANING WITH 

DETERGENTS.
1)

 Prepare the solution of detergent at the concentration 

most suitable for the type of dirt and the surface that is to be 

washed. 

2)

  Detach  the  extension  from  the  handgrip  and  fit  the  double 

lance, lance with adjustable head or detergent kit. Operate the 

high pressure washer, activate the detergent suction control 

on the lance (figs. 10, 12) and spray the surface to be washed, 

working from the bottom upwards.

Leave to work for a few minutes.

..

3)

 Rinse the whole surface well from top to bottom at high 

pressure. 

4)

 After using with detergent, flush out the intake circuit; place 

the detergent suction hose (fig. 8) in a tank of clean water and 

let the pump run for 1 minute with the dosing tap turned fully on 

and the lance in detergent delivery condition.

!

- Water cleaners with the 

“Total Stop” device should be 

considered  as  off  when  the 

omnipolar switch is in the “O” 

position or the plug is unplug-

ged from the socket.

- When the water cleaner is not 

used, close the safety device 

on the handle (fig. 9).

- Dry use of the water cleaner 

causes serious damage to 

pump gaskets.

ATTACHING THE DETER-

GENT INTAKE KIT  (fig. 10) 

(optional accessory)

To suck up the detergent 

solution, fit the kit supplied on 

to the water output of the high 

pressure washer. 

USE OF THE DOUBLE LAN-

CE    (fig.  11) 

(optional ac-

cessory)

The double lance  allows the 

operator to select a low or high 

pressure jet.  The pressure is 

selected with the gun in pos. 

1.  High pressure: pos. 2.  

Low pressure and detergent 

intake: pos. 3.

USING THE ADJUSTABLE 

HEAD (Fig.12) 

(optional 

accessory)

The adjustable head enables 

you to select a low or high 

pressure jet.  The pressure is 

selected by rotating the head. 

High pressure pos. A.

Low pressure pos. B.

FIG.13 

FIG.11

FIG.10

FIG.9

FIG.12







