BRAYER BR1106 - Инструкция по эксплуатации - Страница 8

8

EN

(9) «

». After 15-20 seconds press the button (9)       

«

» again to switch the water supply off and pour 

the water out of the cup.

•  Preheating is over.

MAKING ESPRESSO

•  Switch the water supply on by pressing the button (9) 

« 

 », watch the cup filling with the ready coffee, 

press the button (9) « 

 » again to switch the water 

supply off. Switch the coffee maker off by setting the 

power switch (19) to the position « », the indicator 

(11) will go out.

• 

Wait until the coffee maker cools down and remove 

the filter holder (5) by turning the handle (3) to the left 

« 

 ». Remove the ground coffee remnants and wash 

the filter (6).

• 

For easy removing of the coffee remnants use the 

retainer on the handle (3) to prevent the filter (6) from 

falling off the holder (5).

• 

Notes:

 - The cups should be preliminary heated up, when 

water heats up in the boiler, place the cups on the 

upper tray.

 -

If you need to promptly remove the filter holder (5), 

you have to reduce the pressure in the boiler, switch 

the coffee maker off by pressing the power switch 

(19) to the position « », place a suitable cup under 

the tip (18) and slightly open the steam supply by 
turning the knob (16) « / » to the position « ». 

After the pressure in the boiler is released, you can 

remove the filter holder (5).

MAKING CAPPUCCINO

ATTENTION!

When making coffee do not leave the operating 

coffee maker unattended, as it is necessary to watch 

the cup being filled with ready coffee! 

AFTER PREHEATING:

•  Make sure that the control buttons (8, 9) are in the 

off position.

• 

Make sure that the steam supply is switched off, to 

do that set the knob (16) « / » to the position « ».

• 

Remove the filter holder (5) by turning the handle (3) 

to the left «   » and remove the filter holder (5).

• 

Put ground coffee in the filter (6), slightly tamp the 

ground coffee with the back side of the measuring 

spoon (20).

• 

Install the filter holder (5) into the coffee maker. The 

holder (5) ledges should match the grooves on the 

boiler « 

 », after that turn the filter holder handle 

(3) to the right until bumping «   ».

• 

Wait until the indicator (10) ights up, the coffee maker 

is ready for making coffee.