BRAYER BR1106 - Инструкция по эксплуатации - Страница 5

5

EN

power cord hang from the edge of the table and 

make sure it does not touch hot surfaces or sharp 

edges of furniture.

• 

Do not place the coffee maker on hot surfaces.

•  Do not touch the power cord and the power plug with 

wet hands.

• 

Use only the coffee maker parts and accessories 

supplied with the unit.

• 

Before switching the coffee maker on, make sure that 

all removable parts are installed properly.

•  Ensure that the water level in the water tank is not 

below the minimal mark.

• 

Do not switch the coffee maker on if the water tank 

is empty.

• 

To avoid getting burns by hot steam be careful when 

frothing milk or warming the ready drinks.

• 

The filter holder surface, the cappuccinator pipe and 

the cappuccinator tip can get rather hot. Be cautious 

and careful when in contact with hot surfaces. 

• 

Do not remove the filter holder during coffee maker 

operation.

• 

Let the unit cool down completely before cleaning 

and removing the accessories.

• 

Unplug the coffee maker before cleaning or when you 

are not using it. When unplugging the coffee maker 

hold only the power cord plug and carefully remove it 

from the mains socket, do not pull the power cord — 

this can lead to damage of the power cord or the 

socket or cause short circuit.

• 

For children safety reasons do not leave polyethylene 

bags, used as a packaging, unattended.

ATTENTION! 

Do not allow children to play with polyethylene bags 

or packaging film. 

Danger of suffocation!

• 

The coffee maker is not intended for usage by 

children.

•  Do not leave children unattended to prevent using 

the unit as a toy.

•  Do not allow children to touch the unit and the power 

cord during the coffee maker operation.

• 

Place the unit out of reach of children during the 

operation and cooling down.

• 

This unit is not intended for usage by physically or 

mentally disabled persons (including children) or by 

persons lacking experience or knowledge if they are 

not under supervision of a person who is responsible 

for their safety or if they are not instructed by this 

person on the usage of the unit.

•  From time to time check the power cord and the 

power plug integrity.

• 

If the power cord is damaged, it should be replaced 

by the manufacturer, a maintenance service or 

similar qualified personnel to avoid danger.

• 

Do not repair the unit by yourself. Do not 

disassemble the unit by yourself, if any malfunction 

is detected, and after it was dropped, unplug the unit 

and apply to the service center.