BRAYER BR1106 - Инструкция по эксплуатации - Страница 11

11

EN

3. 

Make citric acid solution: 2 teaspoons of acid to 1 

litre of water and pour the solution into the water 

tank (15). Install the tank (15) back to its place.

4. 

Install the coffee filter (6) into the holder (5) having 

preliminary matched the ledge on the filter (6) with 

the groove on the holder (5) and turn the filter (6) 

counter/clockwise to fix the filter. Do not put ground 

coffee into the filter (6).

5. 

Install the filter holder (5) into the coffee maker. The 

holder (5) ledges should match the grooves on the 

boiler « 

 », after that turn the filter holder handle 

(3) to the right until bumping «   ».

6.  Place a suitable cup on the grid (2).

7.  Insert the power plug into the mains socket.

8. 

Switch the coffee maker on, setting the power 

switch (19) to the «I» position, the indicator (11) 

will light up, and the ready indicator (10) will start 

flashing.

9.  Press the button (9) « 

 » and fill a cup of about 

100 ml capacity with water (it is necessary to drain 

the water from the boiler and fill the boiler with the 

citric acid solution), switch the water supply off by 

pressing the button (9) « 

 » again.

10.  Wait until the indicator (9) lights up, then switch the 

water supply on by pressing the button (9) «

»     

and fill a cup of about 100 ml capacity, press the 

button (9) «

» again to switch the water supply 

off and pour the liquid out of the cup.

11. 

After a while repeat the procedure described in 

the paragraph 10 and fill the cup of about 100 ml 

capacity again.

12.  Press the steam supply button (8) «   », wait 

until the indicator (12) lights up. Put a suitable 

bowl under the tip (18) and slightly open the steam 
supply by turning the knob (16) « / » to the 
position «

». Carefully turn the knob (16) «

/ » to 

the maximal steam release position, release the 

steam for about 1 minute, then close the steam by 

turning the knob (16) « / » to the position « » and 

switch the steam supply off by pressing the button 

(8) « ». 

13. 

Switch the coffee maker off by pressing the on/off 

button (19) «

». Wait for 10-15 minutes.

14. 

Perform the steps 10 and 11 at least 3 times.

15. 

Repeat the cleaning procedure for the steam 

release channels described in the paragraph 12.

16.  With small intervals, repeat the boiler cleaning 

procedure (paragraph 10) until the citric acid 

solution dissolves in the tank (15) completely.

17. 

Switch the coffee maker off by pressing the on/off 

button (19) «I».

18.  Fill the water tank (15) with clear water until 

maximal level and repeat the steps 10, 12 at least 3 

times without the 10-15 minute break.

19. 

Switch the coffee maker off by pressing the on/off 

button (19) « ».

Note:

 to remove the scale you can use special 

descaling agents for coffee makers and coffee