BRAYER BR1106 - Инструкция по эксплуатации - Страница 10

10 EN

6%, cream fat status is not less than 10%.

 -

Clean the tip (18) right after making frothed milk - 

to do that put the tip (17,18) into a glass with water 

and switch the steam supply on by pressing the 

button (8) «   », turn the steam supply knob (16) 
« / » counterclockwise to release some steam. 

After that close the steam supply by turning the 

knob (16) « / » to the position « ». Switch the 

steam supply off by pressing the steam supply 

button (8) « 

 » and switch the coffee maker off.

 -

Wait until the coffee maker cools down and 

remove the tip (18) from the cappuccinator pipe 

(17), wipe the outer side of the cappuccinator pipe 

(17) with a soft damp cloth and wash the tip (18) 

under a water jet.

Note: 

 -

after making frothed milk, if you press the water 

supply button (9) «

 », the indicator (10) will 

be flashing quickly and the water supply will not 

switch on, because the water temperature in the 

boiler is high. To decrease the water temperature, 

put a cup under the tip (18), turn the knob (16) «

/ » to the position « » and drain hot water. 

When the indicator (10) glows constantly, turn the 
knob (16) « / » to the position « », and you 

can resume making coffee.

WARMING THE DRINKS

You can warm up your drinks by putting the 

cappuccinator pipe (17) without the tip (18) into the cup 

with the drink.
•  Press the steam supply button (8) «   », wait until 

the indicator (12) lights up.

•  Put the cappuccinator pipe (17) without the tip (18) 

into the cup with the drink you want to warm up. 

Carefully turn the steam supply control knob (16)  

« / » to the position « ».

•  Close the steam supply by turning the knob (16)   

« / » to the position « ».

• 

Switch the steam supply off by pressing the steam 

supply button (8) «   » again.

• 

Switch the coffee maker off by pressing the on/off 

button (19) « », the indicator (11) will go out.

Note:

 some water or steam may appear from the filter 

holder (5), it is normal.

REMOVING MINERAL SCALE

After 500 cycles of making coffee and frothing milk the 

descaling notification will switch on and the indicators 

(10, 12) will be flashing simultaneously. 

1.  Make sure that the control buttons (8, 9) are in the 

off position.

2.  Make sure that the steam supply is closed. To do 

this turn the knob (16) «  / » to the position « ».