Fulgor Milano FCM 4500 TF X - Инструкция по эксплуатации - Страница 46

EN

16

10 - Preparing coffee with pre-ground coffee (instead of beans)

11 - Delivering hot water

12 - Rinse function

13 - Changing the quantity of hot water

• Press  the   (B4) icon (B4) (fig. 8) and select the pre-

ground coffee function. 

• Extract the machine by pulling it outwards using the 

handles (fig. 7). 

• Lift the central lid, place one measure of pre-ground coffee 

in the funnel (fig. 19), push the appliance in then proceed 

as described in the section “Making coffee using coffee 

beans”. 

  N.B.: You can make just one coffee at a time by pressing 

the   icon (B10) (fig. 12).

• After using the machine with pre-ground coffee, to go 

back to making coffee using beans, deactivate the pre-

ground coffee function by pressing the   icon (B4) (fig. 

8).

NOTE 1: Never introduce pre-ground coffee when the 

machine is off or it could spread through the 

inside of the appliance. 

NOTE 2:  Never add more than 1 measure, otherwise the 

appliance will not make the coffee.

NOTE 3:  Use the measure provided only. 
NOTE 4: Introduce only pre-ground coffee for espresso 

coffee machines into the funnel.

NOTE 5:  If more than one measure of pre-ground coffee is 

used and the funnel clogs, push the coffee down 

with a knife (fig. 21) then remove and clean the 

brewing unit and machine as described in the 

“Cleaning the brewing unit” section. 

• Always make sure the appliance is ready.
• Place a container under the hot water spout (fig. 5).
• Press the   icon (B13) (fig. 20). The appliance displays: 

“HOT WATER PRESS OK”. Press the OK  icon (B9) again 

and hot water is delivered from the cappuccino maker 

into the container underneath. (You should not deliver hot 

water for more than 2 minutes at a time). To interrupt, 

press the   icon (B13) or the   icon (B6). 

  The appliance stops delivery once the set quantity is 

reached. 

Press the   button (B3) to start the “rinse” function. Press the 

key   (B6) to cancel the function at any time.

The machine is set by default to automatically delivery 200 

ml of hot water. 

To change these quantities, proceed as follows:
• Place a container underneath the cappuccino maker (fig. 

5).

• Press the

(B2) to enter the menu (fig. 15) or press the  

 icons (B7) and (B8) (fig. 2) until “PROGRAM HOT 

WATER” is displayed. 

• Press the OK icon (B9) to confirm.

• Select the required quantity of water by pressing the 

icons (B7) and (B8). The progress bar shows the quantity 

of water selected.

• Press the OK icon (B9) to confirm (or the   icon (B6) to 

cancel the operation.

• Press the    (B6) icon (B6) (fig. 18) twice to exit the 

menu.

• The appliance is now reprogrammed with the new settings 

and is ready.