Fulgor Milano FCM 4500 TF X - Инструкция по эксплуатации - Страница 36

EN

6

3 - Built-in installation

Verify the minimum measurements required for correct 

installation of the appliance. The coffee machine must be 

installed in a column and the column must be firmly fixed to 

the wall with commercially available brackets.

IMPORTANT!

• Important: all installation or maintenance operations 

must be performed with the appliance disconnected 

from the mains electricity supply.

• Kitchen furniture in direct contact with the appliance 

must be heat resistant (65°C min).

• To guarantee correct ventilation, leave a gap at the 

bottom of the cabinet (see measurements in figure 1).

• Position the rails on the sides of the cabinet as shown in 

the figure 2. Fix with the screws provided, then extract 

them completely. If the coffee machine is installed over 

a warmer drawer, use the top surface of this as a 

reference to position the rails. In this case, there will be 

no surface to rest the rails on.

IMPORTANT!

• Fix the power cable with the clip (fig. 3). The power 

cable must be long enough to allow the appliance 

to be extracted from the cabinet to fill the coffee 

bean container. The appliance must be earthed in 

compliance with legislation. Electrical connections must 

be performed by a qualified electrician following the 

instructions.

• Position the appliance on the rails, making sure the pins 

are correctly inserted in the housings, then fix it with the 

screws supplied (fig. 4). If the height of the appliance 

requires adjusting, use the spacer disks provided.

• If necessary, correct alignment of the appliance by 

positioning the spacers supplied under or at the sides of 

the support (fig. 5).

• The rail fixing panel must have a thickness suited to the 

fixing screws provided.

• The panel material must be suited to the machine weight 

of approximately 25kg.