Liebherr CN 3503 NoFrost - Инструкция по эксплуатации - Страница 6

4.4 Installing the appliance

In the event that the appliance is damaged, contact the supplier

immediately before connecting to the mains.
The floor at the site must be flat and level.
Do not install the appliance in a location where it is exposed to

direct radiation of the sun, next to a cooker, heater and similar.
Always install the appliance directly against the wall.
Do not install the appliance without assistance.
Standard EN 378 specifies that the room in which you install your

appliance must have a volume of 1 m

3

 per 8 gof R 600a refrigerant

used  in  the  appliance.  If  the  room  in  which  the  appliance  is  in-

stalled is too small, a flammable gas-air mixture may form in the

event of a leakage in the refrigeration circuit. The quantity of re-

frigerant used in your appliance is indicated on the type plate on

the inside of the appliance.

WARNING

Fire hazard due to dampness!

If live parts or the mains lead become damp this may cause short

circuits.

u

The appliance is designed for use in enclosed areas. Do not

operate the appliance outdoors or in areas where it is exposed

to splash water or damp conditions.

WARNING

Fire hazard due to refrigerant!

The refrigerant R 600a is environmentally friendly but flammable.

Escaping refrigerant may ignite.

u

Do not damage the piping of the refrigeration circuit.

WARNING

Fire hazard and danger of damage!

u

Do not place appliances emitting heat e.g. microwaves, toast-

ers etc. on the appliance!

WARNING

Fire hazard and risk of damage due to blocked ventilation grille!

u

Always keep the ventilation grille free. Always ensure that the

appliance is properly ventilated.

u

Detach the connecting cable from the rear of the appliance,

removing  the  cable  holder  at  the  same  time  because  other-

wise there will be vibratory noise!

u

Remove  the  protective  film  from  the  outside  of  the  appli-

ance.*

u

Evenly apply an agent for care of stainless steel, wiping in the

direction of the grain.*

w

Subsequent cleaning becomes easier as a result.*

u

Remove  the  protective  film  from  the  decorative  trims  and

drawer fronts.

u

Remove all transit supports.

u

Dispose of packaging material. See section on packaging dis-

posal.

ATTENTION

Risk of damage due to condensate!

u

Do not install the appliance directly alongside a further refrig-

erator/freezer.

u

Align the appliance so that it stands

firmly and on a level by applying the

accompanying  spanner  to  the  ad-

justable-height feet (A) and using a

spirit level.

u

Then support the door: Extend the

adjustable foot at the turn hinge (B)

until  it  rests  on  the  floor  and  then

make a further 90° turn.

If the appliance is installed in a very damp environment, conden-

sate may form on the outside of the appliance.

u

Always see to good ventilation at the installation site.

4.5 Disposing of packaging

WARNING

Danger of suffocation due to packing material and plastic film!

u

Do not allow children to play with packing material.

The packaging is made of recyclable materials:

-

corrugated board/cardboard

-

EPS moulded parts

-

polythene bags and sheets

-

polypropylene straps

u

Take the packaging material to an official collecting point.

4.6 Connecting the appliance

ATTENTION

Risk of damage to the electronic control system!

u

Do  not  use  stand-alone  inverters  (conversion  of  d.c.  to  a.c./

three-phase) or energy saving plugs.

WARNING

Fire and overheating hazard!

u

Do not use extension cables or multiple socket outlets.

The type of current (alternating current) and voltage at the instal-

lation site have to conform with the data on the type plate (see

section on description of appliance and equipment).

Connect  the  appliance  only  with  a  properly  installed

socket outlet with earthing contact. The socket outlet

must be fused with 10 A or higher.
It must be easily accessible so that the appliance can

be quickly disconnected from the supply in an emer-

gency.

u

Check the electrical connection.

u

Clean the appliance. More information on this is in the section

on cleaning.

u

Plug in the power plug.

4.7 Switching on the appliance

Note

u

To switch on the entire appliance it is necessary only to switch

on the freezer compartment. In so doing, the refrigerator com-

partment is automatically switched on as well.

Put the appliance into operation about 2 hours before first loading

food to be frozen.

Putting into operation

6