Ecosoft Absolute 5-50 - Инструкция по эксплуатации - Страница 27

26

27

This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2019

ENG

REVERSE OSMOSIS SYSTEM INSTALLER AND USER GUIDE

4. 

STEPS FOR INSTALLING REVERSE OSMOSIS SYSTEM

7.

Installation of the faucet.

7.1

7.2

7.3

7.4

7.5

To install drinking water faucet 

3

 drill 12.5 mm (1/2”) diameter hole for 

single way tap or 17 mm (2/3”) diameter hole for two way tap in a conve-

nient location at the sink or countertop. 

Caution! metal shavings can damage your unit, remove them carefully 

as soon as you have drilled the hole. If the mounting surface is ceramic 

or stone, you may need a special carbide drill. 

Mount the faucet on the sink or countertop as shown on the 

figure.  Nut,  lock  washer  and  plastic  washer  on  the  faucet 

shank must fix the faucet firmly on the surface.

Take the blue tube, put on compression nut, ferrule, and put 

plastic insert inside, in that order.

Push the blue tube as deeply as possible into the bottom of 

the  faucet’s  shank,  ensuring  the  compression  ring  is  in  the 

joint. Screw on the compression nut in order to join the tube 

to the faucet.

Installation  of  the  double  lever  faucet  (for  a  system  with 

mineralizing post-filter) is done similarly.

8.

Select  spot  where  you  are  going  to  install  the  filter  and 

make two holes. The distance between the holes in the wall 

must  precisely  correspond  to  that  between  the  holes  in 

the bracket. Allow for at least 100 mm (3.9”) gap between 

the bottom of the filter and floor. Install screw anchors if 

necessary and screw in two screws (not included). 

The distance between the holes is 272 mm (10.7”). 

9.

Insert cartridges into the first and the second housings in 

the direction of water flow (leftwards).

10.

Tighten all the three sumps by hand.

11.

Unplug  the  tube  that  connects  the  third  housing  (in  the 

direction of water flow) with the auto shut-off valve from 

the valve.  

12,5 mm

(1/2”)

17 mm

(2/3”)

272 mm (10.7”)

small rubber gasket
chrome-plated cover

blue tube

large rubber gasket   

large plastic gasket   

lock washer  

nut

counter

1/4 ferrule    

1/4 compression nut

plastic insert