Philips HP6583/02 - Инструкция по эксплуатации - Страница 20

Removing the rechargeable battery

Note: We strongly advise you to have a professional remove the rechargeable 

battery. 

Only remove the rechargeable battery when you discard the appliance. 

Make sure the battery is completely empty when you remove it. 

 1 

 Check if there are any screws in the back or front of the appliance.  

If so, remove them. 

 2 

 Remove the back and/or front panel of the appliance with a 

screwdriver. If necessary, also remove additional screws and/or parts 

until you see the printed circuit board with the rechargeable battery.

 3 

 If necessary, cut the wires to separate the printed circuit board and 

the rechargeable battery from the appliance.

Removing the disposable battery

To remove the disposable batteries, see the appropriate section in the 

user manual.

Guarantee and support

If you need information or suppor t, please visit 

www.philips.com/support

or read the separate worldwide guarantee leaflet. 

Guarantee restrictions

Cutting units are not covered by the terms of the international guarantee 

because they are subject to wear.

Troubleshooting

This chapter summarises the most common problems you could 

encounter with the appliances. If you are unable to solve the problem with 

the information below, contact the Consumer Care Centre in your countr y. 

Problem

Possible cause

Solution

The epilator does 

not work.

The socket used 

to charge the 

epilator does not 

work.

Make sure the socket you use to charge the epilator is live. 

The charging light goes on to indicate that the epilator 

is charging. If you connect the epilator to a socket in a 

bathroom cabinet, you may need to switch on the light in the 

bathroom to make sure the socket is live.  

The rechargeable 

batteries are 

empty.

When the charging light lights up red continuously, the 

batteries are empty and you need to charge the epilator for 

approx. 1 hour. Note: You have to charge the epilator fully 

before first use.

The travel lock is 

active.

To deactivate the travel lock, press and hold the on/off button 

for 3 seconds until the speed lights flash white 2 times. 

You can also connect the epilator to the mains with the 

adapter to deactivate the travel lock.

ENGLISH

20