Simfer B6GM12016 - Инструкция по эксплуатации - Страница 15

15

Your oven has been manufactured as 220-240 V 50/60 Hz. AC power 

supply compliant and requires a 16 Amp fuse. If your power network 

is different that these indicated values, refer to an electrician or your 

authorized service.

When you need to replace the electrical fuse, please ensure that    

electrical connection is made as follows:

•  Phase (to live terminal) brown cable

•  Blue cable to neutral terminal

•  Yellow-green cable to earth terminal

Oven  disconnecting  switches  must  be  in  an  accessible  place  for  final 

user while oven is in its place.

Power supply cable (plug in cable) mustn’t touch hot parts of the appliance.

If supply cord (plug in cable) is damaged, this cord must be replaced 

by the importer or its service agent or an equally competent personnel to 
prevent a hazardous situation.

Gas Connection and Security
Gas Connection and Safety 

1. 

For LPG (cylinder) connection, affix 

metal clamp on the hose coming from LPG 

cylinder. Affix an edge of the hose on hose 

inlet connector behind the appliance by 
pushing to end through heating the hose 
in boiled water. Afterward, bring the clamp 
towards end section of the hose and tighten 
it with screwdriver. The gasket and hose 
inlet connector required for connection is 
as the picture shown below.

NOTE:

 The regulator to be affixed on LPG cylinder should have 300 

mmSS feature.

Gas hose and electric connection of the appliance should 

not pass next to hot areas such as back of the appliance. 

Gas hose should be connected by making wide angle turns 

against breaking possibility. Movement of appliance whose 

gas connection is made may cause gas leakage. 

Main Gas Pipe

Gasket
Hose Inlet Connector

Metal Clamp

Lpg Connection Hose

GB