Kuppersberg HH 668 W - Инструкция по эксплуатации - Страница 9

9

ENGLISH

TECHNICAL PASSPORT

Electric oven

Electrical connection

Â

The oven is manufactured to work 

with  a  one-phase  alternating  current 

(230V  1N~50  Hz)  and  is  equipped 

with a 3 x 1,5 mm2 connection lead of 

1.5  mm  length  with  a  plug  including  a 

protection contact.

Â

A connection socket for electricity 

supply should be equipped with a 

protection pin and may not be located 

above  the  cooker.  After  the  cooker  is 

positioned,  it  is  necessary  to  make  the 

connection socket accessible to the user.

Â

Before  connecting  the  oven  to 

the socket, check if:

B

the fuse and electricity supply 

are able to withstand the cooker load,

B

the electricity supply is 

equipped  with  an  efficacious  ground 

system which meets the requirements 

of current standards and provisions,

B

the plug is within easy reach.

Important!

If  the  fixed  power  supply  cable 

is  damaged,  it  should  be  replaced  at 

the manufacturer or at an authorized 

servicing outlet, or by a qualified person 

to avoid danger.

O P E RAT I O N

Before using the appliance for 

the first time 

Â

Remove  packaging,  clean  the 

interior of the oven,

Â

Take  out  and  wash  the  oven 

accessories with warm water and a little 

washing-up liquid,

Â

Turn on the ventilation in the 

room or open a window,

Â

Heat  up  the  oven  (to  a 

temperature of 250°C for approximately 

30  minutes),  remove  any  stains  and 

wipe the interior carefully. (See section: 

Using the control panel)

Important!

To clean the oven chamber use only 

warm water and a small amount of 

washing-up liquid.

The oven is equipped with a 

retractable  knobs.  In  order  to  select  a 

function do the following:

1.  Gently  press  and  release  a  knob 

which will pop out,

2. Turn the oven functions selection 

knob to the desired function.

Symbols  printed  around  the  knob 

indicate available oven functions.

Important!

The oven features touch control 

panel and display. To activate each touch 

sensor, touch the glass above the sensor 

(indicated  by  a  pictogram).  An  acoustic 

signal will be heard. (See section: Using 

the control panel).

Touch sensor surfaces must be kept 

clean.

Some models are equipped with a 

backlit oven door handle. For additional 

information on oven accessories 

depending  on  the  model,  please  see 

section Features and components.

Oven  handle  backlight  is  turned  on 

during operation and acts as oven cavity 

residual heat indicator, i.e. it turns off 

when the temperature inside the oven 

cavity  drops  below  50°C. The  backlight 

is  on  above  50°C  and  light  intensity 

reflects  the  temperature,  i.e.  the  higher 

the temperature inside the oven cavity 

the higher the backlight intensity.