Electrolux LFG525K - Инструкция по эксплуатации - Страница 3

3

1. SAFETY WARNING

The minimum distance between the hob surface on which the pans stand 

and the lower part of the hood must be 65 cm, unless otherwise speci

fi

 ed 

in the installation instructions. If the hob installation instructions specify a 
greater distance, it must be taken into account.

The air collected must not be conveyed into a duct used to blow off 

smokes from appliances fed with an energy other than electricity (central 
heating systems, thermosiphons, water-heaters, etc.).

Comply with the of

fi

  cial instructions provided by the competent authorities 

in merit when installing the disposal duct. In addition, exhaust air should 
not be discharged into a wall cavity, unless the cavity is designed for that 
purpose.

The room must be well aerated in case a hood and some other heat 

equipment fed with an energy other than electricity (gas, oil, coal heaters, 
etc) operate at the same time. 

In fact the intake hood, disposing of air, could create a vacuum in the room. 

The vacuum should not exceed 0,04mbar. This prevents the gas exhausted 
by the heat source from being intaken again. It is therefore advisable to 
ensure the room contains air taps able to ensure a steady 

fl

 ow of fresh air.

Check the data label inside the appliance; if the symbol ( ) is printed, read 

the following: this appliance has such technical particulars that it belongs 
to class II insulation, therefore it must not be earthed.

Check the data label inside the appliance; if the symbol ( ) is NOT prin-

ted, read the following:   ATTENTION: This appliance must be earthed. 
When making the electrical connections, check that the current socket has 
a ground connection.

When making the electrical connections, check that the voltage values 

correspond to those indicated on the data plate inside the appliance itself. 
In case your appliance is not 

fi

 tted with a supply cord and a plug or with 

other  means for disconnection from the supply mains having a contact 
separation in all poles that provide full disconnection under overvoltage 
category III conditions, that means for disconnection must be incorporated 
in the 

fi

 xed wiring in accordance with the wiring rules. If your unit features 

a power lead and plug, position this so the plug is accessible.

Always switch off the electricity supply before carrying out any cleaning 

or servicing operations on the appliance.

If the supply cord is damaged, it must be replaced by the manufacturer, 

its service agent or similarly quali

fi

 ed persons in order to avoid a hazard.

ENGLISH