Fulgor Milano CH 302 ID TC BK/2 - Инструкция по эксплуатации - Страница 21

20

21

GB

Display 

Description

Probable Cause

Solution

C

The symbol C means that this 

cooking point can be configured

No error, the User is in the 

configuration menu

Place the pan on the induction 

module

C/-

A flashing “C” means that this 

cooking point is currently configured.

“-” appears on the display after 

configuration.

If the symbol “-” does not appear, 

you must check for the possible 

causes of E/5.

No error, the User is in the 

configuration menu

Wait for “-” or stop the configuration 

with the corresponding selection 

key; the C symbol stops flashing.

E

A flashing “E” on all the cooking 

point displays means that, at this 

time, all configurations have been 

erased.

No error, the User is in the 

configuration menu

Manual re-configuration

E/2

(the error code may be 

different for some TCs)

The induction modules are too hot

1. pan/glass temperature too high

2. NTC -> electronic temperature 

too high.

The induction module must cool

E/3

Pan not suitable, such as loss of 

magnetic properties due to the 

temperature of the bottom of the pan

The pan generates working points 

that are not allowed by the induction 

module and that could damage parts 

(such as the IGBT)

1. This error occurs after 8 seconds 

and the cooking point can be used 

again. If the error occurs repeatedly, 

the pan must be removed.

2. If the error occurs even without 

a pan, or it is a pan that normally 

works, the induction module must be 

replaced because it is a hardware 

error.

E/4

Induction modules are not 

configured (all the induction modules 

can be accessed through the bus, 

but no element is assigned to this 

cooking point)

Induction module is not configured

1. Erase the global configuration and 

re-configure.

2. Assign the induction modules 
through the configuration menu.

3. If you cannot configure the 

module, it must be replaced.

E/5

No communication between the UI 

and the induction module

The induction module has no power 

supply voltage. Incorrect connection 

(cable) or induction module defective

Check connections with cables 

and the power supply module; if 

everything is correct, replace the 

induction module

E/6

Mains fault

1. Frequency detection, mains 

defective.

2. Over-voltage

Check connections with cables 

and the power supply module; if 

everything is correct, replace the 

induction module

E/7

Unknown error

This can occur with incompatible 

versions of the induction module or 

Touch Control

Replace the induction module or 

Touch Control

E/8

Fan error

Fan or electronic control defective

Replace the induction module

E/9

Defective induction sensor

The sensor value is invalid, defective 

sensor or electronics

Replace the induction module

E/A

Hardware error

The intrinsic control has detected a 

defective command component

Replace the induction module