Fulgor Milano CH 302 ID TC BK/2 - Инструкция по эксплуатации - Страница 16

16

17

GB

Key Lock (child safety)

BASIC 

Locking/unlocking of the Key Lock

Pressing the Key- Lock button in standby or active 
mode locks the keypad; the stylized key symbol 
lights up. The control continues to operate in the 

previously set mode but can no longer be controlled by other buttons, 
except by the Key-Lock button or the ON/OFF button. Switching off with 
the ON/OFF button is also possible when locked. The Key-lock button 
LED switches off when the Touch control and Key-Lock function are 
switched off. The LED lights again if reactivated (within 10 sec.) until it is 
deactivated by pressing the Key-Lock button once again. The activation/ 
deactivation of the Key-Lock function is not possible in the OFF mode. 

Unlocking/ deactivation of the Key Lock - BASIC

Pressing the Key-Lock button again in standby or active mode 
unlocks the keypad and the stylized key symbol turns off. All sensor 
buttons can be pressed again.

Key lock (child safety feature)

Child safety feature

Key lock:
The child safety can be activated after turning on the Touch pad by 
simultaneously pressing the area selection button in the lower right 
(3A) and the MINUS (5) button and then pressing the area selection 
button in the lower right area (3A) again. There will be an “L” , meaning 
LOCKED (child safety feature against unintended switching-ON). If a 
cooking zone is in the “hot” condition, “L” and “H” will be displayed in 
alternation. This course of operation has to take place within a period 
of 10 seconds, no other key than described above may be operated. 
Otherwise the input will be interrupted because of incompleteness, 
the cooktop will not be locked then. The electronic control remains in 
a locked condition until it gets unlocked, even if the control has been 
switched-OFF and -ON in the meantime. Also a reset of the control 
(after a voltage drop) does not cancel the key lock.

Partial unlock of the buttons for cooking: (child safety)

To unlock the Touch pad simultaneously press the cooking area 
selection button in the lower right (3A) and the MINUS (5) button. 
“L“ (LOCKED) in the display extinguishes and all cooking zones 
show “0“ with a blinking dot. Should a cooking zone be “hot”, “H” is 
displayed instead of the static “0”. After switching- OFF the control, 
the child safety feature is active again.

Permanent removal of the key lock: (child safety)

After switching-ON the control the child safety feature can be 
deactivated. You must simultaneously press the cooking area 
selection button in the lower right (3A) and then press the MINUS 
(5) button alone.
If all steps have been carried out in the right order within 10 seconds 
the key lock gets cancelled and the control is OFF. Otherwise the 
input will be considered incomplete, the control remains locked and 

switches-OFF after 20 seconds.
After a renewed switching-ON by means of the ON/OFF key all 
displays show „0“, the display dots are blinking and the control is 
ready for cooking. If a cooking zone is “hot“ , “H“ will be displayed 
instead of the static „0“.

Booster and induction power 

management (Fig. 2-3)

The cooking area B has a Booster function that goes from 1400 to 
2000 W (during this power increase, the power of cooking area A is 
reduced). The generator, with Booster On, gives the cooking zone power 
that is significantly greater than the rated output. The booster allows a 
particularly rapid heating of the food thereby saving the user time.
The Booster function can be activated as follows:
- The cooking zone must be at the maximum possible level;
- The Booster function is activated by pressing the “+” button again. A 
fixed “P” is displayed on the indication of the cooking zone.
For safety reasons, the Booster function for each cooking zone can only 
be activated for a limited time of 5 minutes. If the pan is removed from the 
cooking zone during the Booster time, the Booster function remains on 
and also the Booster time is not deactivated.
The Booster is switched off by pressing the “-“ button. The “+” has no 
effect whatsoever.