Fulgor Milano CH 302 ID TC BK/2 - Инструкция по эксплуатации - Страница 15

14

15

GB

Timer function

The Timer function can be used as a timer for the 
cooking point or as an independent alarm clock. The 
two rear 7-segment displays (6) are also used for 
displaying the remaining time in minutes, until the 
timer alarm goes off.

Timer selection

The simultaneous activation of the “+” and “-” is used for selecting the 
timer function. There are two different timer modes:
- Timer for the cooking point (the timer is assigned to a cooking point). 

When the set time runs out, there is an audible and visual signal and 
the relative cooking point turns off.

- Independent alarm (the timer works without reference to a cooking point)
- If an independent alarm timer is set, only the display (6) will turn on, but if 

you have programmed a timer associated with a cooking are, the LED 
“8A” or “8B” will be on.

When the set time runs out, there is an audible and visual signal in this 
mode as well, but the cooking points are not turned off.

Selecting a timer

a timer is selected by simultaneously pressing the plus and minus keys 
with the control activated. If you have previously selected a cooking point, 
the timer of that cooking point will light up. Plus, this will be indicated by 
the flashing decimal point on the display (LED timer 8A-8B) of the cooking 
point. If no cooking point had been previously selected, the cooking alarm 
timer will be activated. In this case, all the decimal points will be off ( 
8A - 8B).
If different timers are active, you can select the desired timer by pressing 
the plus and minus keys several times. The timers of the active cooking 
points will be turned off in clockwise order. After the last cooking point 
timer, the cooking alarm timer will be selected and after that the first 
cooking point timer will be selected again. The selection time is 10 
seconds. This time is set from scratch at each change of the value of the 
timer by pressing the plus or minus key. When this time runs out, the timer 
with the shortest time set will be displayed. You can end the selection 
early by selecting a cooking point. 

Setting the timer value

when a timer has been selected, you can change the timer value using 
the plus or minus keys.
If a timer value has not been set, pressing the minus key will set a value 
of 30 minutes, which can then be changed.
By holding down the plus or minus key longer, the set value will 
change faster. At a setting value of 99 or 01, the automatic repeat will 
automatically stop. If the timer of a cooking point is set, this will be 
indicated on the related timer LED (8A-8B) of the cooking point, even at 
the end of selection, by a static or flashing decimal point (static if the timer 
is set but not displayed because there are other timers with less time) 
(flashing if the timer is set and is displayed because it is the timer with the 
shortest time). In the case of setting a generic cooking timer.

Turning off the timer early

You can turn off the timer by setting the timer value to 00. In the case of a 
cooking point timer, the corresponding cooking point will stay on.
Counting down the time set on the timer: the time countdown starts as 
soon as a timer is set. If the value is changed using the plus or minus 
keys, the timer starts on a full minute and any seconds that may have 
elapsed are cancelled.

Signal of a timer whose set time has run out

If the timer value has reached 00, this will be indicated by an audible 
and visual signal. If a cooking point timer has reached the set value, the 
corresponding cooking point will be turned off. Any cooking points or 
timers selected will be deselected.
The timer value (00) is automatically displayed again and flashes. If it is a 
cooking point timer, the corresponding decimal point will also flash. The 
signal lasts for 2 minutes, unless it is stopped earlier by pressing any key.
After the signal, all the active cooking point displays will be visible again.