Makita EM2600U - Инструкция по эксплуатации - Страница 15

15

Caution during operation:

If the throttle lever is opened fully during a no-load operation, the engine revolutions increase over 10,000 min

-1

. Never operate the engine at a 

higher speed than required, and keep the revolutions at an approximate speed of 6,000 - 8,000 min

-1

.

CAUTION: Always reduce the engine revolutions when the equipment is not being used for work. 

Operating the equipment at high revolutions when not being used for work will shorten the lifespan of the equipment.

Stopping

– Release the throttle lever (3) fully, and when the engine rpm has lowered, 

push the I-Stop Switch (on/off)/Start-Stop Switch (1) to “STOP” position to stop 
the engine.

– Be aware that the cutting head may not stop immediately, and always allow it 

to slow down and stop fully by itself.

CAUTION: The cutting tools listed below must only be resharpened by an 

authorized facility. Manual resharpening will result in imbalances of 
the cutting tool, which will cause vibrations and damage to the 
equipment.

– cutter blade (star blade (4 teeth))

A professional resharpening and balancing service is provided by Authorized 
Service Agents.

NOTE: To increase the service life of the cutter blade (star blade) the blade may 

be turned over to allow both cutting edges to wear. 

Resharpening the cutting tool

EM2600L

EM2600U