Husqvarna 129R 9671933-01 - Инструкция по эксплуатации - Страница 10

• If you spill fuel on your clothing, change clothing

immediately.

• Do not get fuel on your body, it can cause injury. If

you get fuel on your body, use a soap and water to

remove the fuel.

• Do not start the engine if you spill oil or fuel on the

product or on your body.

• Do not start the product if the engine has a leak.

Examine the engine for leaks regularly.

• Be careful with fuel. Fuel is flammable and the fumes

are explosive and can cause injuries or death.

• Do not breathe in the fuel fumes, it can cause injury.

Make sure that there is a sufficient airflow.

• Do not smoke near the fuel or the engine.
• Do not put warm objects near the fuel or the engine.
• Do not add the fuel when the engine is on.
• Make sure that the engine is cool before you refuel.
• Before you refuel, open the fuel tank cap slowly and

release the pressure carefully.

• Do not add fuel to the engine in an indoor area. Not

sufficient airflow can cause injury or death because

of asphyxiation or carbon monoxide.

• Tighten the fuel tank cap carefully or a fire can

occur.

• Move the product at a minimum of 3 m (10 ft) from

the position where you filled the tank before a start.

• Do not put too much fuel in the fuel tank.
• Make sure that a leak cannot occur when you move

the product or fuel container.

• Do not put the product or a fuel container where

there is an open flame, spark or pilot light. Make

sure that the storage area does not contain an open

flame.

• Only use approved containers when you move the

fuel or put the fuel into storage.

• Empty the fuel tank before long-term storage. Obey

the local law on where to dispose fuel.

• Clean the product before long-term storage.
• Remove the spark plug cable before you put the

product into storage to make sure that the engine

does not start accidentally.

S

Safety instructions for maintenance

• If you cannot adjust the idle speed to make the

cutting attachment stop, speak to your service

center. Do not use the product until the product is

correctly adjusted or repaired.

ASSEMBLY

WARNING: Read the safety chapter before

you assemble the product.

To install the handlebar

1. Remove the screw behind the throttle handle.
2. Move the throttle handle to the right side of the

handlebar (Picture 25).

3. Align the hole behind the throttle handle with the

hole in the handlebar.

4. Let the screw go through the holes. Tighten the

screw.

5. Install the mounting components (Picture 25)

between the arrows on the shaft. Tighten with

screws.

To install the harness clamp

1. Put the upper harness clamp above the shaft.

Note: The upper harness clamp and the lower

harness clamp must be above the arrow on the

shaft.

2. Put the throttle wire in the of lower harness clamp

groove. Put the lower harness clamp with wire in

groove below the shaft.

3. Align the upper and lower harness clamp screw

holes.

4. Attach two screws into the screw holes.
5. Tighten the screws to attach the harness clamp.

To adjust the harness

WARNING: If you must release from the

product and the harness in an emergency

situation, use the harness release function

(Picture 23).

1. Put on the harness.
2. Adjust the harness for the best work position.
3. Adjust the side straps until the weight is equally

distributed across your shoulders (Picture 26).

4. Adjust the harness until the cutting attachment is

parallel to the ground.

5. Let the cutting attachment stay lightly on the ground.

And then adjust the harness clamp to balance the

product correctly.

Note: If you use a grass blade, it must balance

approximately 10 cm (4 inches) above the ground to

keep the grass blade from stones and so on.

10

191 - 002 -