Husqvarna 129R 9671933-01 - Инструкция по эксплуатации - Страница 12

G

Gasoline

Oil

5 l

100 ml (3,4 oz)

To make the fuel mixture

Note: Always use a clean fuel container when you mix

the fuel.

Note: Do not make more than 30 days quantity of fuel

mixture.

1. Add half of the gasoline quantity.
2. Add the full quantity of oil.
3. Shake the fuel mixture to mix the contents.
4. Add the remaining gasoline quantity.
5. Shake the fuel mixture to mix the contents.
6. Fill the fuel tank.

To add fuel

• Always use a fuel container with an antispill valve.
• If there is some fuel on the container, remove the

unwanted fuel and let the container dry.

• Make sure that the area near the fuel tank cap is

clean.

• Shake the fuel container before you add the fuel

mixture to the fuel tank.

To start and stop

To examine before start

1. Examine the product for missing, damaged, loose or

worn parts.

2. Examine the nuts, screws and bolts.
3. Examine the blades.
4. Examine the locknut. Make sure that the locknut has

a minimum locking force of 1.5 Nm (1,1 ft lb). Torque

the locknut to 35-50 Nm (26-36 ft lb).

5. Examine the air filter.
6. Examine the throttle trigger lockout and the throttle

control.

7. Examine the stop switch.
8. Examine the product for fuel leaks.

To start a cold engine

1. Push the primer bulb 10 times (Picture 31).
2. Pull the choke control up (Picture 32).
3. Hold the body of the product on the ground with your

left hand (Picture 33). Do not step on the product.

Pull the starter rope handle slowly until you feel

some resistance. Then pull the starter rope handle

with force.

Note: Do not pull the throttle trigger while you start

the engine.

4. Continue to pull the starter rope handle until the

engine starts or tries to start (max. 3 pulls). If the

engine starts or tries to start, push the choke control

down. Continue to pull until the engine starts. Wait

60 seconds after a start before you pull the throttle

trigger.

CAUTION: Do not pull the starter rope

until it stops. Do not let go of the starter

rope when it is fully extended. Release

the starter rope slowly. Failure to obey

these instructions can cause damage to

the engine.

To start a warm engine

1. Push the primer bulb 10 times.
2. Pull the starter rope until the engine starts.

To stop

• Push the stop switch to stop the engine. (Picture 21)

Note: The stop switch automatically goes back to its

initial position.

To operate the grass trimmer

CAUTION: Make sure that you slow the

engine to idle speed after each operation. A

long period at full throttle without a load on

the engine can cause damage to the engine.

Note: Clean the cover of the trimmer head when you

attach a new trimmer line to prevent vibrations. Examine

other parts of the trimmer head and clean if it is

necessary.

To trim the grass

1. Hold the trimmer head immediately above the

ground at an angle (Picture 36) . Do not push the

grass trimmer line into the grass.

2. Decrease the length of the grass trimmer line by

10-12 cm (4-4.75 in) and decrease engine speed to

decrease the risk of damage to plants.

3. Use 80 % throttle when you cut grass near objects

(Picture 37).

To cut the grass

1. Make sure that the grass trimmer line is parallel to

the ground when you cut (Picture 38).

2. Do not push the trimmer head to the ground. The

ground and the product can be damaged.

3. Do not let the trimmer head touch the ground

continuously, it can cause damage to the trimmer

head.

12

191 - 002 -