Al-ko BC 4125 II-S 112941 - Инструкция по эксплуатации - Страница 19

Startup

440 248_a

19

3. Lock the gas lever as described under “Cold

start”.

4. Pull the starter cord a maximum of 6 times.

➯

the engine starts.

5. Keep the gas lever pressed down until the en-

gine runs smoothly.

Engine does not start

1. Set the choke to the “RUN” position.
2. Pull the starter cord 5 times.

If the engine still does not start

1. Wait 5 minutes and then try again with the gas

lever pressed down.

OPERATION

Always  let  the  engine  run  in  the  upper  speed

range during trimming and cutting.

Safety instructions

CAUTION!

Please  observe  the  safety  and  warning

notices  in  this  manual  and  on  the  pro-

duct.

CAUTION!

During  extended  periods  of  use  the  vi-

brations  can  cause  disorders  of  the

blood vessels or nervous systems of the

fingers,  hands  and  wrists.  You  may  ex-

perience parts of your body going numb,

twinges,  pains  or  changes  in  the  skin.

If  such  symptoms  arise,  please  consult

your doctor!

Never hold the string head higher than knee

level when the device is in operation.
Never work on a slippery hillside or slope.
When  mowing  on  sloping  ground,  always

stand downhill of the cutting device.
Never use the device in the vicinity of highly

flammable liquids or gases – Risk of fire and/

or explosion!
After contact with a foreign object:

Switch off the engine.
Examine the device for damage.

Persons  who  are  not  familiar  with  the  trim-

mer  should  practise  handling  it  with  the  en-

gine switched off.

Avoiding recoil

CAUTION!
Risk of injury from uncontrolled kick-

back!

Do not use cutting blade near solid obst-

acles.

Dense vegetation, young trees or brushwood can

jam the cutting blade and stop it turning.

Avoid  jamming  by  noting  the  direction  in

which  the  vegetation  leans  and  then  cutting

from the opposite side.
If the cutting blade becomes entangled during

cutting:

Switch off the engine immediately.
Hold  up  the  device  so  that  the  cutting

blade does not jump or break.
Push the caught material away.

Trimming

1. Examine  the  terrain  and  determine  the  desi-

red cutting height.

2. Guide and hold the string head at the desired

height.

3. Swing  the  device  from  side  to  side  in  a

sweeping, scythe-like motion.

4. Always keep the string head parallel with the

ground.

Close trimming

1. Hold the device so that it is tilted forward at a

slight angle and moves just above the ground.

2. Always trim away from your body.

Trimming along fences and foundations

CAUTION!
Risk of injury from uncontrolled kick-

back!

Do not use cutting blade near solid obst-

acles.

1. Move the device slowly and with care, ensu-

ring that the string does not impact with obst-

acles.

Trimming around tree trunks

1. Guide the device slowly and carefully around

tree  trunks,  ensuring  that  the  cutting  string

does not touch the tree bark.

2. Mow from left to right around tree trunks.