Levenhuk SkyMatic 127 GT MAK - Инструкция по эксплуатации - Страница 17

Levenhuk Limited Warranty

Batteries safety instructions

Care and maintenance

Always purchase the correct size and grade of battery most suitable for the intended use.
Always replace the whole set of batteries at one time; taking care not to mix old and new ones, 
or batteries of different types.
Clean the battery contacts and also those of the device prior to battery installation.
Make sure the batteries are installed correctly with regard to polarity (+ and -).
Remove batteries from equipment that is not to be used for an extended period of time.
Remove used batteries promptly.
Never attempt to recharge primary batteries as this may cause leakage, fire, or explosion.
Never short-circuit batteries as this may lead to high temperatures, leakage, or explosion.
Never heat batteries in order to revive them.
Remember to switch off devices after use.
Keep batteries out of the reach of children, to avoid risk of ingestion, suffocation, or poisoning.

Never, under any circumstances, look directly at the Sun through this device without a special 
filter, or look at another bright source of light or at a laser, as this may cause PERMANENT 
RETINAL DAMAGE and may lead to BLINDNESS.
Take necessary precautions when using the device with children or people who have not read or 
who do not fully understand these instructions.
Do not try to disassemble the device on your own for any reason, including to clean the mirror. 
For repairs and cleaning of any kind, please contact your local specialized service center.
Protect the device from sudden impact and excessive mechanical force.
Do not touch the optical surfaces with your fingers. To clean the telescope exterior, use only 
special cleaning wipes and special optics cleaning tools from Levenhuk.
Store the device in a dry, cool place away from hazardous acids and other chemicals, away from 
heaters, open fire and other sources of high temperatures.
Replace the dust cap over the front end of the telescope whenever it is not in use. This prevents 
dust from settling on the mirror or lens surfaces.
Seek medical advice immediately if a small part or a battery is swallowed.

1. Convert the angular position into a 24-bit number (see “Slow-Goto command”).
2. Send the following 8-byte command:
a. Set Az position: 80, 4, 16, 4, PosHighByte, PosMedByte, PosLowByte, 0 b. Set Alt position: 80, 
4, 17, 4, PosHighByte, PosMedByte, PosLowByte, 0
3. Hand controller returns “35”. 

10

All Levenhuk telescopes, microscopes, binoculars and other optical products, except for accessories, carry 
a lifetime warranty against defects in materials and workmanship. All Levenhuk accessories are warranted 
to be free of defects in materials and workmanship for six months from date of retail purchase. Levenhuk will 
repair or replace such product or part thereof which, upon inspection by Levenhuk, is found to be defective in 
materials or workmanship. As a condition to the obligation of Levenhuk to repair or replace such product, the 
product must be returned to Levenhuk together with proof of purchase satisfactory to Levenhuk.
This warranty does not cover consumable parts, such as batteries.
A Return Authorization (RA) Number must be obtained in advance of return. Contact the local Levenhuk branch 
to receive the RA number to be displayed on the outside of your shipping container. All returns must be 
accompanied by a written statement setting forth the name, address and telephone number of the owner, 

15