Makita DVC864LZ - Инструкция по эксплуатации - Страница 14

14 ENGLISH

Troubleshooting for wireless activation function

Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual, 

do not attempt to dismantle the tool. Instead, ask Makita Authorized Service Centers, always using Makita replace

-

ment parts for repairs.

State of abnormality

Probable cause (malfunction)

Remedy

The wireless activation lamp does 

not light/blink.

The wireless unit is not installed into 

the tool. 

The wireless unit is improperly installed 

into the tool.

Install the wireless unit correctly in the tool.

The terminal of the wireless unit and/or 

the slot is dirty.

Gently wipe off dust and dirt on the terminal of the 

wireless unit and clean the slot of the tool.

The wireless activation button on the 

tool has not been pushed.

Push the wireless activation button on the tool 

briefly.

The stand-by switch on the cleaner is 

not set to "AUTO".

Set the stand-by switch on the cleaner to "AUTO".

No power supply

Supply the power to the tool and the cleaner.

Cannot finish tool registration / can

-

celling tool registration successfully.

The wireless unit is not installed into 

the tool. 

The wireless unit is improperly installed 

into the tool.

Install the wireless unit correctly in the tool.

The terminal of the wireless unit and/or 

the slot is dirty.

Gently wipe off dust and dirt on the terminal of the 

wireless unit and clean the slot of the tool.

The stand-by switch on the cleaner is 

not set to "AUTO".

Set the stand-by switch on the cleaner to "AUTO".

No power supply

Supply the power to the tool and the cleaner.

Incorrect operation

Push the wireless activation button briefly and 

perform the tool registration/cancellation procedures 

again.

The tool and cleaner is away from each 

other (out of the transmission range).

Get the tool and the cleaner closer to each other. 

The maximum transmission distance is approxi-

mately 10 m however it may vary according to the 

circumstances.

Before finishing the tool registration/

cancellation; 

- the switch trigger on the tool is pulled 

or;  

- the power button on the cleaner is 

turned on.

Push the wireless activation button briefly and 

perform the tool registration/cancellation procedures 

again.

The tool registration procedures for the 

tool or the cleaner has not finished.

Perform the tool registration procedures for the tool 

and the cleaner at the same timing.

Radio disturbance by other appliances 

which generate high-intensity radio 

waves.

Keep the tool and the cleaner away from the appli

-

ances such as Wi-Fi devices and microwave ovens.