Снегоуборщики AL-KO SNOWLINE 560 II - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
GB
31
469186_c
Snow Line 560 II, 620 II, 620E II
Maintaining the auger drive
Adjusting the control cable
If the auger drive no longer engages when the engine is
running, the control cable must be adjusted.
Caution!
▪
Switch off the engine before adjusting the con-
trol cable.
▪ If the auger drive mechanism cannot be disen
-
gaged, switch off the engine. Do not attempt
repair; contact a qualified workshop.
1. Loosen the lock nut (
41-1
).
2.
Turn the adjustment on the control cable in the
direction of the arrow (
41-2
) until the control
cable does not sag (i.e. is somewhat taut) when
the clutch lever is pressed. Hold the cable while
tightening so that it does not twist.
3. Tighten the lock nut.
4.
Check the adjustment by starting the engine and
engaging the auger drive.
5. If the auger drive still does not engage and
disengage properly, have the machine repaired by
a qualified workshop.
Replacing the shear pins
If the auger is blocked, the shear pins (
25-1
)
may
break in order to ensure safe operation.
▪
Replace broken shear pins with original re-
placement parts. Using unauthorised replace
-
ment parts may cause severe damage to the
machine!
▪ See the replacement parts list when ordering
replacements.
1.
Switch off the machine and disconnect the spark
plug connector.
2.
Remove damaged shear pins
(
42-2
).
3.
Check the shaft for damage.
4. Insert new shear pins and secure with safety split
pins (
42-1
)..
Storage
If the machine is stored for a long period of time, for ex
-
ample, after the winter season, heed the following:
Danger - risk of explosion!
Do not store the machine near an open flame or
heat source.
Empty the carburettor.
Start the engine.
Close the fuel tap.
Wait until the engine dies.
Allow the engine to cool.
Store in a dry area that is inaccessible to children
and unauthorised persons.
Either empty the petrol tank or fill it completely.
Remove the engine key.
Disconnect the spark plug connector.
Disposal
Do not dispose of worn-out machines,
batteries or rechargeable batteries in the
household rubbish!
Packaging, device and accessories are made
of recyclable materials and are to be disposed
of accordingly.
Repairs
Repairs may be performed only by qualified workshops.
Have a qualified workshop perform and inspection:
After running onto an obstacle.
If the engine stops suddenly.
If the auger or impeller is damaged.
