Снегоуборщики AL-KO SNOWLINE 560 II - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
GB
27
469186_c
Snow Line 560 II, 620 II, 620E II
Safety
Warning!
Never leave the engine running in an enclosed
space. Risk of poisoning!
Store petrol and oil only in appropriate containers.
Allow the machine to cool before storing it in an
enclosed space.
If there is still petrol in the tank, make sure that
there is no ignition source in the enclosed space,
such as a heater or clothes dryer.
Add or empty petrol and oil in an open space only
when the engine is switched off and cold.
Do not overfill the tank (petrol expands).
Do not smoke while filling the tank.
Do not open the tank cap while the engine is run-
ning or hot.
Replace the tank or cap if damaged.
Always secure the tank cap securely.
If petrol has spilled out:
Do not start the engine
Do not attempt ignition
Collect spilled petrol with a binding agent or
cloth and dispose of appropriately.
Clean the machine
If engine oil has spilled out:
Do not start the engine
Collect spilled petrol with an oil binding agent
or cloth and dispose of appropriately.
Clean the machine
When disposing of used oil:
▪
do not throw into the rubbish
▪
do not pour into sewers or drains or onto the
ground
We recommend returning used oil in a closed container
to a recycling facility or service centre.
Adding engine oil
1.
Remove the oil cap (
22 -1
) and store in a clean
area.
2. Add oil using a funnel.
3. Check the oil level.
4. Replace the oil cap tightly and clean.
See the engine manual for information about checking
the oil level.
Adding petrol
1.
Remove the tank cap (
22 -2
) and store in a
clean area.
2. Add petrol using a funnel.
3. Replace the tank cap tightly and clean.
Getting ready for operation
Caution!
Do not operate a damaged machine!
Perform a visual inspection before using.
The camera symbol on the following pages refer
-
ences the illustrations on pages 4–7.
Adjusting the clearance height
Danger - risk of injury!
Adjust the clearance height only if the engine
is switched off and the auger is not in motion!
▪
Adjust the clearance height to avoid taking
in gravel or other objects.
▪
Look out for uneven places such as ruts,
manhole covers or paving stones.
1.
Place the machine on an level surface.
2.
Loosen the left and right skid plate clamping screws
(
23-1
).
3. Raise the clearing plate to the desired height and
attach the skid plates. Make sure that both skid
plates are spaced equally so that the clearing plate
runs parallel to the ground (
23-2
).
