DEWALT DCD996NT - Инструкция по эксплуатации - Страница 15

13

English

Hammerdrill Operation (Fig. E)

1.  Select the desired speed/torque range using the gear shifter 

to match the speed and torque to the planned operation. 
Set the torque adjustment collar 

 5 

 to the hammer symbol.

2.  Select the high speed 3 setting by sliding the gear shifter 

 6 

back (away form the chuck).

3.  When drilling, use just enough force on the hammer to 

keep it from bouncing excessively. Prolonged and too much 
force on the hammer will cause slower drilling speeds and 
potential overheating.

4.  Drill straight, keeping the bit at a right angle to the work. Do 

not exert side pressure on the bit when drilling as this will 
cause clogging of the bit flutes and a slower drilling speed.

5.  When drilling deep holes, if the hammer speed starts to 

drop off, pull the bit partially out of the hole with the tool 
still running to help clear debris from the hole.

6.  For masonry, use carbide-tipped bits or masonry bits. A 

smooth, even flow of dust indicates the proper drilling rate.

MAINTENANCE

Your 

D

e

WALT

 power tool has been designed to operate 

over a long period of time with a minimum of maintenance. 
Continuous satisfactory operation depends upon proper tool 
care and regular cleaning.

WARNING: To reduce the risk of serious personal 
injury, turn tool off and disconnect battery pack 
before making any adjustments or removing/
installing attachments or accessories.

 An accidental 

start-up can cause injury.

The charger and battery pack are not serviceable.

Lubrication

Your power tool requires no additional lubrication.

Cleaning

WARNING:

 Blow dirt and dust out of the main housing 

with dry air as often as dirt is seen collecting in and around 
the air vents. Wear approved eye protection and approved 
dust mask when performing this procedure.

WARNING: 

Never use solvents or other harsh chemicals 

for cleaning the non-metallic parts of the tool. These 
chemicals may weaken the materials used in these parts. 
Use a cloth dampened only with water and mild soap. 
Never let any liquid get inside the tool; never immerse any 
part of the tool into a liquid.

Optional Accessories

WARNING:

 Since accessories, other than those offered 

by 

D

e

WALT

, have not been tested with this product, use 

of such accessories with this tool could be hazardous. 
To reduce the risk of injury, only 

D

e

WALT

 recommended 

accessories should be used with this product.

Consult your dealer for further information on the 
appropriate accessories.

Protecting the Environment

Separate collection. Products and batteries marked 
with this symbol must not be disposed of with normal 
household waste.
Products and batteries contain materials that can 

be recovered or recycled reducing the demand for raw 
materials. Please recycle electrical products and batteries 
according to local provisions. Further information is available at 

www.2helpU.com

.

Rechargeable Battery Pack

This long life battery pack must be recharged when it fails 
to produce sufficient power on jobs which were easily done 
before. At the end of its technical life, discard it with due care for 
our environment:
•  Run the battery pack down completely, then remove it from 

the tool.

•  Li-Ion cells are recyclable. Take them to your dealer or a 

local recycling station. The collected battery packs will be 
recycled or disposed of properly.