DEWALT DCD996NT - Инструкция по эксплуатации - Страница 11

9

English

batteries (combo kits) can be air shipped as excepted if the Watt 
Hour rating of the battery pack is no greater than 100 Whr.
Regardless of whether a shipment is considered excepted 
or fully regulated, it is the shipper's responsibility to consult 
the latest regulations for packaging, labeling/marking and 
documentation requirements.
The information provided in this section of the manual is 
provided in good faith and believed to be accurate at the time 
the document was created. However, no warranty, expressed or 
implied, is given. It is the buyer’s responsibility to ensure that its 
activities comply with the applicable regulations.

Transporting the FlEXVOlT

TM

 Battery

The 

D

e

WALT

 FLEXVOLT

TM

 battery has two modes: 

Use

 and 

Transport

.

Use Mode: 

When the FLEXVOLT

TM

 battery stands alone or is in 

a 

D

e

WALT

 18V product, it will operate as an 18V battery. When 

the FLEXVOLT

TM

 battery is in a 54V or a 108V (two 54V batteries) 

product, it will operate as a 54V battery.

Transport Mode: 

When the cap is attached to the FLEXVOLT

TM

battery, the battery is in Transport mode. Keep the cap for 
shipping.
When in Transport mode, strings 
of cells are electrically 
disconnected within the pack 
resulting in 3 batteries with a 
lower Watt hour (Wh) rating as compared to 1 battery with a 
higher Watt hour rating. This increased quantity of 3 batteries 
with the lower Watt hour rating can exempt the pack from 
certain shipping regulations that are imposed upon the higher 
Watt hour batteries. 
For example, the Transport 
Wh rating might indicate 
3 x 36 Wh, meaning 3 
batteries of 36 Wh each. 
The Use Wh rating might 
indicate 108 Wh (1 battery implied).

Storage Recommendations

1.  The best storage place is one that is cool and dry away 

from direct sunlight and excess heat or cold. For optimum 
battery performance and life, store battery packs at room 
temperature when not in use.

2.  For long storage, it is recommended to store a fully charged 

battery pack in a cool, dry place out of the charger for 
optimal results.

nOTE:

 Battery packs should not be stored completely depleted 

of charge. The battery pack will need to be recharged before 
use.

Labels on Charger and Battery Pack

In addition to the pictographs used in this manual, the labels 
on the charger and the battery pack may show the following 
pictographs:

Example of Use and Transport Label Marking

Read instruction manual before use.

See 

Technical Data

 for charging time.

Do not probe with conductive objects.

Do not charge damaged battery packs.

Do not expose to water. 

Have defective cords replaced immediately.

Charge only between 4 ˚C and 40 ˚C.

Only for indoor use.

Discard the battery pack with due care for the 
environment.

Charge 

D

e

WALT

 battery packs only with designated 

D

e

WALT

 chargers. Charging battery packs other 

than the designated 

D

e

WALT

 batteries with a 

D

e

WALT

 charger may make them burst or lead to 

other dangerous situations.

Do not incinerate the battery pack.

USE (without transport cap). Example: Wh rating  
indicates 108 Wh (1 battery with 108 Wh). 

TRANSPORT (with built-in transport cap). Example: 
Wh rating indicates 3 x 36 Wh (3 batteries of 36 Wh).

Battery Type

The DCD991 and DCD996 operate on a 18V Li-Ion XR and 
XR FLEXVOLT

TM

 battery packs

These battery packs may be used: DCB181, DCB182, DCB183, 
DCB183B, DCB184, DCB184B, DCB185, DCB546. Refer to 

Technical Data

 for more information.

Package Contents

The package contains:
1    Brushless cordless drill/driver (DCD991)
1    Brushless cordless hammerdrill (DCD996)
1   Li-Ion battery packs (M1, P1, T1)
2   Li-Ion battery packs (M2, P2, T2)
3   Li-Ion battery packs (M3, P3, T3)
1   Tool Connect™ App instruction manual