DREAME Bot Robot Vacuum and Mop D9 Pro Black (RLS5-BL0) - Инструкция по эксплуатации - Страница 7

8

9

EN

EN

1. Remove the protective matter

2. Install the side brush

Click

Preparation Before Use

Note: 

Install the side brush until it clicks into place.

3. Fasten the damp-proof pad

· It is recommended that the damp-proof pad be fastened on the wooden floor.

· If you need to remove the damp-proof pad, please remove it slowly to avoid 

adhesive residue.

Select a clean location to place the charging dock. Tear off the 

adhesive tape at the bottom of the damp-proof pad, and stick the 

pad on the ground as shown in the figure.

Note:

4. Connect to a power outlet

5. Start recharging

· Keep the immediate area 1.5m in front of the charger and 0.5m to both sides 

of the charging dock clear of objects.

· To ensure you can connect to the robot with your phone well, make sure the 

robot and charging dock are within WiFi range.

· Do not place the charging dock in an area with direct sunlight or where other 

objects might block the signal, as this may hinder the robot from returning to 

the charging dock.

Battery Level Indicator

＞ 1.5 m

＞ 0.5 m

＞ 0.5 m

Preparation Before Use

Note:

Note:

 It is recommended to fully charge your robot before first-time use.

Place the charging dock on the level ground against the wall and 

connect it to a power outlet.

Place the robot onto the charging dock to recharge. The robot will 

turn on automatically and begin recharging.

· White: Battery level is more than 15% 

· Orange: Battery level is less than 15%