Bertazzoni MAS100 6 MFE D XT - Инструкция по эксплуатации - Страница 7

7 

ATTENTION: The appliance conforms with the regulations of directives 
90/396EEC (Gas Directive) regarding gas appliances for domestic use and the 
like, 73/23 (Low Voltage Directive) regarding electrical safety and 2004/108/CE, 
(EMC Directive) regarding electromagnetic compatibility. 

Ensure that the electricity supply is switched off before making the connection. This 
appliance must be earthed. 
Connection to the electricity supply must be made through the flex cable that is 
already attached to the rear of the cooker. The end of the cable is tucked into the 
cooker storage area. 
Connection to the supply must be made through fixed wiring. It cannot be connected 
to a normal domestic power socket. A double pole switched cooker box should be 
used with contact separation of at least 3mm. 
Turn on each hob zone to check that all elements are functioning correctly. Remove 
all packaging and combustible items from the oven. Turn on the oven selector switch 
and thermostat knob to check that the oven is functional on all modes.

Adaptation to different    

Before performing any maintenance operation, disconnect the appliance from                      

types of gas

                    the gas supply and electricity network. 

Replacing the gas nozzles to operate with another type of gas:  

Follow the instructions below to change the burner nozzles on the work 
surface: 

- 

Isolate the appliance from the electric outlet to avoid any type of electric contact. 

- 

Remove the grids from the work surface. 

- Remove 

the 

burners. 

- 

Unscrew the nozzles using a 7 mm spanner, and replace them (Fig.

4

) with those 

needed for the new type of gas according.

 Fig 4 

Follow the instructions below to change the oven burner nozzle (model 90x60 
single oven): 

- 

Remove the oven level (Fig.5). 

- Loosen 

the 

screw 

V

 and pull out the burner from the support being careful not to 

damage the ignition plug and the thermocouple (Fig. 6). 

- Unscrew 

the 

nozzle 

R

 using a 10 mm spanner and replace it with the nozzle 

needed for the new type of gas according. 

Fig 5                                                         Fig 6

Follow the instructions below to change the oven burner nozzle (model 60x60 
single oven): 

Remove the oven level (Fig.7). 
- Loosen 

the 

screw 

V

 and pull out the burner from the support being careful not to 

damage the ignition plug and the thermocouple (Fig.7).