Bertazzoni MAS100 6 MFE D XT - Инструкция по эксплуатации - Страница 4

4 

APPLIANCE MAINTENANCE 

ATTENTION: IMPORTANT WARNINGS 

For cookers resting on a base 

ATTENTION: If the cooker rests on a base, take the measures necessary to prevent the cooker from sliding 
along the support base. 

For cookers with electric ovens 

The unit becomes hot during use. Do not touch the heating elements inside the oven. 

For cookers with electric ovens 

ATTENTION: The accessible parts can become hot during use. Keep children away from the appliance. 

For the food warmer compartment (or drop leaf in our case) 

ATTENTION: The internal parts of the food warmer can become hot during use. 

For glass doors 

Do not use abrasive cleaning products or metal spatulas with sharp edges to clean the oven door’s glass 
since this could scratch the surface and the glass could break. 

Do not use steam cleaners to clean the appliance. 

Replacing parts              Before performing any maintenance operation, disconnect the appliance from the 

gas supply and electricity network. 

To replace parts such as knobs and burners, just remove them from the seats 
without disassembling any part of the cooker. 
To replace the oven bulb, just unscrew the protection cap that projects out inside the 
oven.  

                                                                                 Fig.2 

WARNING: Before replacing the bulb, disconnect the appliance from the electric 
power supply. 
WARNING: The power cord supplied with the appliance is connected to that 
appliance with an X type connection (in compliance with standards EN 60335-1, EN 
60335-2-6 and subsequent amendments) for which it can be installed without the 
use of special tools, with the same type of cord as the one installed. 
If the power cord becomes worn or damaged, replace it based on the information 
reported in types of power cords paragraph . 
WARNING: If the power cord is replaced, the installer shall ensure that the ground 
cable is longer than the phase cables and also shall comply with the warnings 
regarding the electric connection. 
To replace the power cable, lift the terminal board’s cover and replace the cable. To 
access the terminal board in cookers with a 3x2.5mm² cable, the back panel on the 
rear of the appliance must be removed. The power cord should be replaced only by 
qualified personnel. 
Before disposing of the packaging, please ensure you have removed all the 
components.                  
The up-stand is packed separate and is taped to the back of the cooker. Other 
components can be found inside the ovens. All packaging and covering films must 
be removed before the installation can commence. 

All electric cookers should be installed by a qualified electrician in accordance with 
IEE regulations and local electricity provider rules. Building regulations must be