Bertazzoni MAS100 6 MFE D XT - Инструкция по эксплуатации - Страница 36

36 

The side shelf runners and shelves can be cleaned In a dishwasher.  
This is not advisable with the telescopic runners as the detergent may remove the 
lubrication on the runners.  

Removing and refitting the telescopic runners  

                                       -     The telescopic runners fit any shelf level, and work with both the grill tray and  

       wire shelves.  
- 

Locate the two spring clips at the front and back of the runners.  

- 

Gently pull down the front spring clip. 

- 

Pull the runner away from the oven side - be careful not to strain the clip.  

- 

Repeat steps 2 - 3 on rear spring clip to remove runner.  

- 

To replace, hold runner level with front section of side support and clip in place.  

       Repeat with rear section.  

Removal of roof tray  

The roof tray above the grill element can be removed for cleaning. 

    -     Support the grill element with one hand while removing the 2 wing nuts that hold    
          the element in place.  

- 

The element position will drop slightly allowing removal of the top liner. 

- 

Once cleaned and dried, the top liner can be placed back into position, above

       the element, and re-secured with the two wing nuts.  
- 

The liner will only fit into one position so care must be taken to locate it on the 

       rear lugs and the front large lip must be facing downwards.  
- 

Do not use the oven unless the liner is fitted and the element has been re- 

       secured with the wing nuts.  

    Removal of the soft

close drawer  

 -    Pull the drawer forward.  - 
- 

Locate the grey clips behind the runners at the front of the drawer. 

- 

Push in the clips and the drawer will release.  

Replacing the soft close drawer  

- 

Replace the drawer on to runners and close.