Bertazzoni MAS100 6 MFE D XT - Инструкция по эксплуатации - Страница 11

11 

GAS HOB 

Using the gas hob 

As the following points: 

-  To light a burner, press in the control

knob (Fig.14A-14B)  and turn it anti-

clockwise, to the large flame position.  

- 

Continue to hold the knob In until the burner lights. Adjust the flame as required, 
continue to hold the knob in far 5 to 10 seconds before releasing  

- 

The Chef Top (optional) is powered by the gas burners.  

- 

See page 7 for usage instructions. 

                                                 Fig 14A                                                 Fig 14B

The dual wok burner      The central burner of the dual wok burner can be used independently of

the outer    

                                       burner to give further flexibility. 

-  To light the central burner, press in the control knob (Fig.15A-15B) and turn it 

anti-clockwise to the bold single ring position  

- 

Continue to hold the knob in until the burner lights. Adjust the flame as  required 
The minimum setting is the lighter single ring position. 

-  To light the outer burner as well as the central burner. turn the knob to the bold 

double ring. Adjust the flame as required  

       The minimum setting far the central and outer burner is the lighter double ring      
       position.  

                                                 Fig 15A                                                   Fig 15B                                                                                                       

Lighting the burners       The symbol above each knob indicates which burner that knob controls.  

- 

A flame failure (thermocouple) device on each burner acts as a safety gas cut-
off

in case the flame is accidentally blown out.  

- 

A thermocouple detects the absence of a flame and stops the supply of gas.  

- 

The thermocouple must be heated for a few seconds when the burner is ignited 
before the knob is released.  

To light a burner:  

1 Push and turn the control knob anti-clockwise to the large flame 

     position. The ignition candle will spark and ignite the gas. 

    2   Keep the control knob pressed In for 5-10 seconds to activate the flame failure  
        device, then release the knob. Adjust the flame between the large and small     
        flame symbols as required. 

In the event of a power failure the burners can be lit with a match or gas lighter The 
flame failure devices will continue to function normally. 

GAS BURNER DIMENSION

Burner Diam 

(mm)

Power Utilization

Auxiliary 

Ø 50 mm 

1 kW 

Use with smaller pans for boiling and simmering and the preparation of 

sauces. 

Semi-rapid (and 

Chef Top) 

Ø 70 mm 

1.75 kW 

Use for normal frying and boiling in medium and small pans. 

Rapid 

Ø 95 mm 

3 Kw 

Use with large and medium pans of water for frying and rapid boiling. 

Dual inner/outer  Ø 43/140 mm  0.48-5 kW 

Use with woks,griddles and frying pans or for large pans and rapid 

boiling.