TESY CN 04 250 EIS W 304190 - Инструкция по эксплуатации - Страница 8

Обогреватели TESY CN 04 250 EIS W 304190 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.

Если остались вопросы, задайте их в комментариях после инструкции.

"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Страница:
/ 204
Загружаем инструкцию
background image

8

       

Operation and Storage Manual 

EN

of illumination of all LEDs. Upon pressing any of the 

buttons the brightness increases for 8 seconds and it is 

then reduced again.

g. 

If the display shows “t0” or “t1“, this means that the 

self-diagnostic system has found a problem with the 

temperature sensor. “t0” indicates a disconnected 

cable at the sensor, while “t1” indicates short circuit 

at the sensor. In this case the electric convector will 

be automatically switched off and it can be switched 

on again only after the problem has been fixed. The 

problem has to be handled by a qualified specialist.

h. 

Upon switching on the power supply the display 

will show hyphens “----“ for 2 seconds instead of 

temperature of time.

i. 

When the digital display shows the temperature the 

“Temperature” LED is lit, and when it shows the time, 

the “Timer” LED is lit.

PROTECTION 

 •

The appliance is equipped with a safety thermo turn-

off device, which automatically turns the heater off in 

cases of extreme temperature of the panel heater /i.e. 

overheating of the appliance/.

 •

The safety thermo turn-off device will automatically 

restore the heater operation when the temperature 

of the appliance falls below the permissible ultimate 

values.

CLEANING

 •

It is compulsory first to turn off the appliance 

through its power switch and to disconnect it from 

the power socket. Before starting the cleaning 

session you should wait until the panel heater cools 

down in a disconnected state. 

 •

The panel heater can be cleaned with little efforts at 

the appliance rear part – just press the “P”-shaped 

braces /figure 2/ at the back of the appliance so 

that you can dismantle it and consequently you can 

clean the rear part of the appliance. 

 •

Clean the heater body with damp cloth, vacuum 

cleaner or a brush.

 •

Never immerse the appliance into water – there is 

danger for your life from electric shock!

 •

Never use gasoline, thinner or hard abrasive 

products to clean the appliance, because they will 

damage the appliance coating.

STORAGE

 •

Before putting the panel heater away let it cool 

down after you have disconnected it from the 

power socket

 •

Use the appliance original packing to store it, if the 

panel heater will not be in use for a long period of 

time. By storing the product in its original packing you 

protect it from excessive dirt and dust accumulation.

 •

Never put a hot panel heater in its packing!

 •

It is necessary the product to be stored at a dry and 

dark place, protected from direct sun light.

 •

It is explicitly forbidden to store the panel heater in 

damp and wet premises. 

MAINTENANCE OPERATIONS OF THE APPLIANCE 

 •

In case of appliance malfunction, please contact the 

authorized service center closest to your location. /

service centers are indicated in appliance warranty 

documents/.

 

Important

: In case of a claim and/or violation of 

your consumer rights, please contact the supplier of 

this appliance at the indicated locations or via the 

Internet page of the company: www.tesy.com

DIMENSIONS OF HEATED VOLUME AND HEATED 
AREA OF A ROOM / APPLIANCE MODELS

Model

Heated volume  Heated area

CN 04 050 EIS W

 - 500W 

10* - 15 m

3

4* - 6 m

2

CN 04 100 EIS W 

- 1000W

20* - 30 m

3

8* - 12 m

2

CN 04 150 EIS W

 - 1500W

30* - 45 m

3

12* - 18 m

2

CN 04 200 EIS W

 - 2000W

40* - 60 m

3

16* - 24 m

2

CN 04 250 EIS W

 - 2500W

50* - 70 m

3

20* - 28 m

2

CN 04 300 EIS W

 - 3000W

60* - 80 m

3

24* - 32 m

2

* Minimum guaranteed heated volume (area) for heating at an average 

capacity of heat transmission factor λ=0.5 W/(m

2

K) for a heated room. 

Higher values of heated volume (area) can be achieved at an average 

value of λ=0.35 W/ (m

2

K). Standard height of heated rooms – 2.5 meters.

Warning: Do not cover the appliance 

in order to prevent overheating! 

Environment protection instructions 

Obsolete electric appliances contain valuable 

materials and consequently they should not 

be treated as domestic waste! We ask for your 

cooperation and your active contribution to protect 

the resources and the environment. Please submit 

your out-of-use appliances to the organized buy-back 

stations (if there are such).

Полезные видео

Характеристики

Оцените статью
tehnopanorama.ru
Остались вопросы?

Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)

Задать вопрос

Часто задаваемые вопросы
Как посмотреть инструкцию к TESY CN 04 250 EIS W 304190?
Необходимо подождать полной загрузки инструкции в сером окне на данной странице
Руководство на русском языке?
Все наши руководства представлены на русском языке или схематично, поэтому вы без труда сможете разобраться с вашей моделью
Как скопировать текст из PDF?
Чтобы скопировать текст со страницы инструкции воспользуйтесь вкладкой "HTML"