GIGABYTE GA 8N775 - Инструкция по эксплуатации - Страница 73

Appendix

- 73 -

English

(4) Making a SATA Driver Disk

To install operating system onto a serial ATA hard disk successfully, you need to install the SATA
controller driver during OS installation. Without the driver, the hard disk may not be recognized during
the Windows setup process.  First of all, copy the driver for the SATA controller from the motherboard
driver CD-ROM to a floppy disk. See the instructions below about how to copy the driver in MS-DOS
mode

(Note)

. Prepare a startup disk that has CD-ROM support and a blank formatted floppy disk.

Step 1: Insert the prepared startup disk and motherboard driver CD-ROM in your system.  Boot from the
startup disk. Once at the A:\> prompt, change to the CD-ROM drive (example: D:\>).  At the D:\>
prompt, type the following two commands. Press ENTER after each command (Figure 12):

c d   b o o t d r v

m e n u

Step 2: When the controller menu (Figure 13) appears, remove the startup disk and insert the blank
formatted disk. Select the controller driver by pressing the corresponding letter from the menu. For
example, from the menu in Figure 13, press E to select 

nVIDIA Series ATA(XP) 

for  Windows operating

system. Your system will then automatically zip and transfer this driver file to the floppy disk.

Figure 12

Figure 13

Figure 14

(Note) For users without a startup disk. Use an alternative system and insert the GIGABYTE

motherboard driver CD-ROM. From the CD-ROM drive (example: D:\) double click the

MENU.exe

 file in the 

BootDrv

 folder(Figure 14). A command prompt window will open similar

to that in Figure 13.

Step 3:
Press 0 to exit when the procedure is complete. You have copied the SATA driver successfully.