Rommelsbacher EKS 1510 - Инструкция по эксплуатации - Страница 35

35

Step 14:

If the appliance is not needed any 
more, switch it off and pull the 
mains plug.

Step 15:

Clean the appliance and the 
accessories.

Power save mode:

After 10 min. without operation, 
the appliance switches to power 
save mode, without heating of the 
thermoblock. The operation pilot 
lamp blinks slowly (every 2 sec.). 
By actuating the switch ON/OFF, the 
appliance can be activated again. 
After a short heating-up phase, the 
appliance is ready for use.

Frothing milk

•  For having perfect results, we recommend ...
  … using refrigerated milk only
  … using a stainless steel jug.
•  Dip the hot water/steam nozzle in the milk and start frothing in the upper third of the milk. Hold the jug a little slant 

and slightly move it up and down. The nozzle must remain under the milk surface as otherwise the milk froth will be 
too large-pored. 

(After a few trials and with a little practice, you will quickly find the correct method).

• 

Attention:

 Make sure that the holes in the nozzle are always clean and not clogged.

• 

Attention:

 For moving the nozzle, only touch it at the upper plastic part.

• 

Attention:

 After frothing, the system must be cooled manually (see steps 12 – 15).

Nähere Informationen 

hierzu finden Sie unter 

„Reinigung und Pflege“.

•  Check the water tank 

regularly, refill water if 
necessary. 

•  Check the drip pan 

regularly, empty it if 
necessary.

Step 2:

Position the portafilter without filter 
insert at the marking of the brew 
head and lock it by turning it to the 
right as far as it will go.

Step 3:

Place a vessel below the outlet of 
the hot water/steam nozzle.

Warning: 

Casing, brew head, 

portafilter, filter inserts and hot 
water/steam nozzle are getting hot 
during use!

Step 1:

Prepare the appliance.