Rommelsbacher EKS 1510 - Инструкция по эксплуатации - Страница 32

32

Step 12:

Stop hot water supply. 
Turn the rotary knob to the top.
NOTE: The appliance carries excess 
water back into the water tank via a 
recirculation system!

Repeat step 11 + 12

3 times.

Step 13:

If the appliance is not needed any 
more, switch it off and pull the 
mains plug.

Refilling the water tank

•  Avoid that the water tank is drained completely during use! We recommend checking the water level prior to each 

use and refilling water up to the “MAX” marking. 

•  The pump generates a loud pump noise in case the water in the tank runs low.
•  For refilling the water tank, there is no need to take out the water filter. 
•  After refilling the water tank, bleed the system if necessary.

Warning: 

Casing, brew head, 

portafilter, filter inserts and hot 
water/steam nozzle are getting hot 
during use!

Step 2:

Fill the water tank with fresh tap 
water up to the “MAX” marking!

Step 3:

Insert the water tank. 
Make sure the water tank is inserted 
as far as it will go on the gasket.

Step 4:

 (bleeding)

Position the portafilter without filter 
insert at the marking of the brew 
head and lock it by turning it to the 
right as far as it will go.

Step 5:

 (bleeding)

Place a vessel below the outlet of 
the hot water/steam nozzle.

Step 6:

 (bleeding)

Choose the function 
“espresso/hot water”.

Step 7:

 (bleeding)

Switch the appliance on.
The appliance heats up and the 
temperature pilot lamp glows red 
permanently. 
When the lamp exinguishes, the 
appliance is ready for use. The 
operation pilot lamp glows blue 
permanently.

Step 1:

Remove the water tank 
(previously remove the portafilter if 
necessary). 
Empty residual water.

•  Check the water tank 

regularly, refill water if 
necessary. 

•  Check the vessel regularly, 

empty it if necessary.

•  This process may cause loud 

pump noises.