Clatronic KA 3139 - Инструкция по эксплуатации - Страница 24

E

N

G

LI

S

H

ENGLISH

24

•  In order to protect children or frail individuals from the ha-

zards of electrical equipment, please ensure that this device 
is only used under supervision. This device is not a toy. Do 

not 

allow small children to play with it.

Special Safety Instructions for this Device

•  Place the coffee machine on a fi rm and fl at surface. Position 

it so that it cannot tip over.

•  The water tank must only be fi lled with cold water!
•  Never open the fi lter cover during the boiling process, as 

otherwise this may cause burns.

•  During operation steam is emitted from above the fi lter 

holder! This may cause condensation to form on the upper 
cover of the device. This is normal and does not impair the 
functioning of the device!

•  Do not place the device directly next to a gas or electric 

cooker or any other source of heat.

•  Do not move the device while it is in operation.
•  Before opening the water tank, switch the device off and 

allow it to cool down for at least 30 seconds.

Initial Operation of the Device

►  Remove all packaging and transportation safety devices 

from the device that may be present. Rub all of the parts 
with a damp cloth. This will remove any dust that may have 
accumulated during transport. Reinsert all of the parts in the 
reverse order.

►  Before making coffee for the fi rst time, allow water to pass 

through the device two to three times in order to clean it.

Electrical Connection

►  Insert the mains plug into a properly installed 230 V, 50 Hz 

socket with earthing contact. For information please see the 
type plate on the device.

►  Please ensure that the device is switched off. The lamp in 

the 

I/O

 switch is off.

Operation

►  Fold open the water tank lid.
► Now 

fi ll cold water for the desired number of cups into the 

rear water container, as shown on the water level indicator. 
Please do not overfi ll the device (max. 10 cups).
You can use the pot to fi ll the water tank. Turn the lid in the 
„

UNLOCK

“ direction in order to remove it.

►  Turn over the lower fold of the paper fi lter (size 1x4) and 

place it in the fi lter funnel. Then fi ll it with coffee powder.

►  Now close the lid of the water tank.
►  Position the lid such that the two arrows are in line with one 

another (see illustration). Tighten the lid in the direction 
of the word „

LOCK

“. When the lid is correctly closed, the 

recess is facing the spout. Place the pot on the space 
provided.

►  Turn the device on. The control lamp in the switch lights up.
►  The brewing process lasts approximately 10-15 minutes.
►  Your device has an anti-drip system. If the pot is removed 

before all of the water has passed through the fi lter, this 
prevents the coffee from dripping on to the base. If there is 
still water in the tank or fi lter, please ensure that you place 
the pot back under the fi lter in order to prevent the device 
from overfl owing.

►  When no more coffee is fl owing through the fi lter you can 

remove the pot.

►  Turn the device off. The control lamp goes off.
►  It is not necessary to unscrew the lid in order to pour the 

coffee out of the pot.

►  If you would like to keep the rest of the coffee warm, the 

switch must remain in the „

I

“ position. The hotplate will keep 

the coffee warm until you move the switch to „

0

“.

쫵

 The 

fi lter holder can be removed from the machine by its 

handle. This makes it easier to dispose of the old coffee 
fi lter, for example.

Descaling 

It is necessary to descale the coffee machine if the preparation 
time becomes considerably longer.

쫵

  Only a commercially available decalcifi er on a citric acid 

base should be used for descaling. Please use the quanti-
ties stated on the pack or instruction leafl et.

►  After descaling, please boil fresh water without coffee in the 

machine several times (approx. 3-4 times).

•  This will remove any residues from the descaling process. 
• Do 

not

 use this water for consumption.

Cleaning 

►  Before cleaning, always remove the mains plug and wait 

until the device has cooled down.

►  The exterior of the device should be cleaned as necessary 

with a slightly damp cloth – without any additives.

► The 

fi lter insert can be cleaned in the usual manner in warm 

soapy water.

05-KA 3139 CTC.indd   24

05-KA 3139 CTC.indd   24

12.09.2007   12:21:12 Uhr

12.09.2007   12:21:12 Uhr