BRAYER BR1108 - Инструкция по эксплуатации - Страница 9

9

EN

•  Set the milk supply intensity control knob (17) to the 

middle position. 

• 

Install one of the coffee filters (21 or 22) into the filter 

holder (20) matching the ledge on the filter (21 or 22) 

with the hole on the holder (20) and turn the filter (21 

or 22) counter/clockwise. Do not add ground coffee 

into the filter (21 or 22) when preparing the coffee 

maker for work. 

• 

Install the filter holder (20) into the installation place  «

» and turn the handle (4) to the right as far as it will 

go « » (pic. 2, 3, 4). 

•  Place a cup of suitable height and capacity of at least 

300 ml on the tray grid (2). 

•  Direct the cappuccinator pipe (15) into the cup using 

the cappuccinator pipe angle adjustment bar (14).

Note:

 You can change the length of the cappuccinator 

pipe (15) by turning the pipe (15) counterclockwise, then 

extend it to the required length, and fix the pipe (15) by 

turning it clockwise (fig. 9). 

•  Insert the power plug into the mains socket. 

• 

Switch the coffee maker on by setting the power switch 

(11) «0/I» to the position «I», the indicator (7, 8, 9) will 

light up and start flashing. 

• 

When the coffee maker is ready for operation, the 

indicator (7, 8, 9) will glow constantly. 

•  To switch the cleaning mode on press the 

«Cappuccino»-button (8) twice. After cleaning is 

finished, all the light indicators of the control buttons 

(7, 8, 9) will light up. 

• 

After you finish cleaning the coffee maker, switch the 

coffee maker off by setting the switch (11) «0/I» to the 

position «0». 

•  Pour the water out of the cup, take the container (18), 

pull it towards yourself and remove (pic. 1), remove the 

cappuccinator lid (16) from the container (18), pour the 

remaining water from the container (18). Slightly lift the 

front part of the tray (1) and remove it, pour the water 

out of it and install the tray (1) back to its place. 

• 

Turn the filter holder handle (4) to the left and remove it 

(pic. 2, 3, 4). Wait until the filter holder (20) cools down 

completely and remove the installed filter (21 or 22) 

turning it counter/clockwise. Wash the filter (21 or 22) 

and install it into the filter holder (20). 

•  If necessary, clean the boiler and the cappuccinator lid 

(16) several times. 

• 

After cleaning the coffee maker is ready for operation. 

CHOOSING THE APPROPRIATE CUP

• 

Before making coffee, please, select a cup of 

appropriate capacity according to the table:

Drink

Estimated amount of the ready 

drink

Espresso: 

оne / 

double 

90 ml/130 ml

Cappuccino:  

оne / 

double

150 ml/270 ml

Latte: 

one / 

double

280 ml/400 ml