BRAYER BR1108 - Инструкция по эксплуатации - Страница 15

15

EN

•  After making the necessary amount of frothed milk stop 

the process by pressing the «Cappuccino»-button (8) 

again.

•  Remove the cup with frothed milk and use the frothed 

milk for the intended purpose.

• 

After you finish using the coffee maker, switch the 

coffee maker off by setting the switch (11) «0/I» to the 

position «0».

•  If there is some milk left in the cappuccinator, remove it 

and put the cappuccinator into the fridge (pic. 12), if you 

used all milk during making coffee, it is recommended 

to remove the cappuccinator and clean it (see the 

chapter «CAPPUCCINATOR CLEANING»).

CAPPUCCINATOR CLEANING 

•  We recommend cleaning the cappuccinator after the 

milk container (18) is empty.

•  Take the container (18) and remove it (pic. 1), remove 

the cappuccinator lid (16) from the container (18).

•  Wash the container (18) with a neutral detergent, 

remove the milk intake pipe from the cappuccinator lid 

(16) and wash it, rinse all the parts, dry them and install 

the milk intake pipe back to its place.

•  Turn the steam nozzle counterclockwise and remove 

it from the cappuccinator (16) body (pic. 11), wash the 

nozzle.

•  Remove the cappuccinator pipe (15) by turning the 

pipe (15) counterclockwise, rinse the pipe (15), install it 

back to its place, fix the pipe (15) by turning it clockwise 

(fig. 9).

•  Grasp the left side and raise the silicone plug (pic. 14), 

rinse the cappuccinator lid (16) under a warm water jet, 

close the silicone plug.

•  Install the steam nozzle back to its place and turn it 

clockwise (pic. 15).

• 

Prepare the coffee maker as described in the chapters 

above, but do not add ground coffee into the filter (21 or 

22).

•  Place a cup of suitable height and capacity on the grid 

(2). 

•  Fill the container (18) with water, do not exceed the 

maximal level mark.

•  Install the cappuccinator lid (16) on the container (18) 

and install the cappuccinator back to its place until the 

lock clicking.

•  Direct the cappuccinator pipe (15) into the cup using 

the cappuccinator pipe angle adjustment bar (14), if 

necessary, change the length of the cappuccinator pipe 

(15) (fig. 9).

•  Turn the frothed milk supply (intensity) control knob (175) 

to the right to the position « 

 ».

• 

Switch the coffee maker on by setting the power switch 

(11) «0/I» to the position «I», the indicator (7, 8, 9) will 

light up and start flashing.

• 

When the coffee maker is ready for operation, the light 

indicator (7, 8, 9) will glow constantly.

•  Press and hold the «Latte»-button (9) for 3 seconds, the 

indicators « » and « » will light up.