BRAYER BR1108 - Инструкция по эксплуатации - Страница 14

14

EN

Notes:

 you can adjust the milk foam supply intensity when 

making latte.
•  Insert the power plug into the mains socket.

• 

Switch the coffee maker on by setting the power switch 

(11) «0/I» to the position «I», the indicator (7, 8, 9) will 

light up and start flashing.

• 

When the coffee maker is ready for operation, the light 

indicator (7, 8, 9) will glow constantly.

• 

To make one cup of latte use a small filter (21) and 

press the «Latte»-button (9) once; the light indicator «

» will light up.

• 

To make two cups of latte use a big filter (20) and press 
the «Latte»-button (9) twice; the light indicator «

» will 

light up.

Note:

 if you need to switch the coffee maker off during the 

latte making, press the «Latte»-button (9) again.
•  Remove the cup with the ready drink from the grid (2).

• 

After you finish using the coffee maker, switch the 

coffee maker off by setting the switch (11) «0/I» to the 

position «0».

• 

Wait until the coffee maker cools down, remove the 

filter holder (20) and wash the filter (21 or 22).

•  If there is some milk left in the cappuccinator, remove it 

and put the cappuccinator into the fridge (pic. 12), if you 

used all milk during making coffee, it is recommended 

to remove the cappuccinator and clean it (see the 

chapter «CAPPUCCINATOR CLEANING»).

MAKING FROTHED MILK

•  You can make necessary amount of frothed milk anytime.

•  You can use the frothed milk for making hot chocolate, 

macchiato, masala tea etc.

•  It is important that milk for making frothed milk is fresh and 

cold and without additives.

•  Take usual whole milk with fat status from 4% to 6%, 

cream fat status is not less than 10%.

• 

Prepare the coffee maker as described in the chapters 

above, but do not add ground coffee into the filters (21 or 

22).

•  Place a cup of suitable height and capacity on the grid (2).

•  Direct the cappuccinator pipe (15) into the cup using 

the cappuccinator pipe angle adjustment bar (14), if 

necessary, change the length of the cappuccinator pipe 

(15) (fig. 9).

•  Turn the frothed milk supply (intensity) control knob (17) 

to the right (in this position it produces more frothed milk) 

(pic. 11).

Notes:

 you can adjust the milk foam supply intensity when 

making.
• 

Switch the coffee maker on by setting the power switch 

(11) «0/I» to the position «I», the indicator (7, 8, 9) will light 

up and start flashing.

• 

When the coffee maker is ready for operation, the light 

indicator (7, 8, 9) will glow constantly.

•  Press and hold the «Cappuccino»-button (8) for 3 

seconds, the indicators « » and « » will light up.