BRAYER BR1108 - Инструкция по эксплуатации - Страница 10

10

EN

Notes:

 this table has guide values of the amount of the 

ready drink and is only used to select the volume of the 

required cup.

RULES OF MAKING ESPRESSO

• 

Use fresh-ground coffee beans or ground coffee for 

«espresso» coffee makers.

• 

Make even and slightly tamp the ground coffee in the 

filter (21 or 22), you can do it with the back side of 

the measuring spoon (23) (pic. 5, 6, 7).

• 

Strength of ready coffee depends on the quality and 

grinding degree of coffee beans.

• 

If coffee is pouring out too long, this means the 

coffee powder is too fine it is tamped too strongly; in 

this case use coarse-ground coffee and choose the 

tamping degree experimentally.

THERMOMETER (5)

•  The built-in thermometer (5) shows the boiler 

temperature, if the boiler temperature is over 80°С, 

you can make coffee.

• 

When the coffee maker is not used, the thermometer 

(5) will show the room temperature.

MAKING ESPRESSO
ATTENTION!

 -

Do not remove the filter holder (20) during making 

coffee.

 -

Do not remove the filter holder (20) right after making 

coffee, as there is redundant pressure inside, wait a 

little before removing the filter holder (20). 

•  Remove the lid (12), remove the water tank (13).

•  Fill the tank (13) with cold water, do not exceed the 

maximal level mark, install the tank (13) back to its place.

• 

Install one of the coffee filters (21 or 22), depending on 

the amount of ready coffee, into the filter holder (20) 

matching the ledge on the filter (21 or 22) with the hole 

on the holder (20) and turn the filter (21 or 22) counter/

clockwise.

• 

Add the required amount of ground coffee into the filter 

(21 or 22) with a measuring spoon (23) and slightly tamp 

the coffee in the filter (21 or 22) with the back side of the 

measuring spoon (23) (pic. 5, 6, 7). 

• 

Install the filter holder (20) into the installation place «

» and turn the handle (4) to the right as far as it will go «

» (pic. 2, 3, 4).

•  Place a cup of suitable height and capacity (see the table 

CHOOSING THE APPROPRIATE CUP) on the grid (2); if 

you use small cups, take the pullout tray (3) by the lower 

part and pull it towards yourself, place the cups on it.

•  Insert the power plug into the mains socket (pic. 8).

•  Note: - During preliminary heating, you can warm up the 

cups that will be used for making coffee by placing them 

on the tray (6).

• 

Switch the coffee maker on by setting the power switch 

(11) «0/I» to the position «I», the indicator (7, 8, 9) will 

light up and start flashing.