BRAYER BR1108 - Инструкция по эксплуатации - Страница 12

12

EN

MAKING CAPPUCCINO

ATTENTION! When making cappuccino be careful to 

avoid burns by outgoing hot steam.

•  Make sure that the removable tray (1) and the tray grid 

(2) are installed to their places.

•  Fill the tank (13) with cold water, do not exceed the 

maximal level mark, install the tank (13) back to its 

place.

•  Take the container (18), pull it towards yourself and 

remove it (pic. 1), remove the cappuccinator lid (16) 

from the container (18).

•  Fill the container (18) with milk, do not exceed the 

maximal level mark.

•  Install the cappuccinator lid (16) on the container (18) 

and install the cappuccinator back to the installation 

place until the lock clicking.

• 

Install one of the coffee filters (21 or 22) into the filter 

holder (20) matching the ledge on the filter (19 or 20) 

with the hole on the holder (20) and turn the filter (21 or 

22) counter/clockwise.

• 

Add the required amount of ground coffee into the filter 

(21 or 22) with a measuring spoon (23) and slightly 

tamp the coffee in the filter (21 or 22) with the back side 

of the measuring spoon (23) (pic. 5, 6, 7). 

• 

Install the filter holder (20) into the installation place «

» and turn the handle (4) to the right as far as it will 

go « » (pic. 2, 3, 4).

•  Place a cup of suitable height and capacity on the grid 

(2) (see the table «CHOOSING THE APPROPRIATE 

CUP»).

Note:

 During preliminary heating, you can warm up the 

cups that will be used for making coffee by placing them on 

the tray (6).
•  Direct the cappuccinator pipe (15) into the cup using 

the cappuccinator pipe angle adjustment bar (14), if 

necessary, change the length of the cappuccinator pipe 

(15) (fig. 9).

•  Turn the frothed milk supply (intensity) control knob (17) 

to the right (in this position it produces more frothed 

milk). Turn the frothed milk supply (intensity) control knob 

(17) to the left (in this position it produces less frothed 

milk) (pic. 10, 11).

Notes:

 you can adjust the milk foam supply intensity when 

making cappuccino.
•  Insert the power plug into the mains socket.

• 

Switch the coffee maker on by setting the power switch 

(11) «0/I» to the position «I», the indicator (7, 8, 9) will 

light up and start flashing. 

• 

When the coffee maker is ready for operation, the light 

indicator (7, 8, 9) will glow constantly.

• 

To make one cup of cappuccino use a small filter (21) 

and press the «Cappuccino»-button (8) once; the light 

indicator « » will light up.