BRAYER BR1108 - Инструкция по эксплуатации - Страница 13

13

EN

• 

To make two cups of cappuccino use a big filter (20) 

and press the «Cappuccino»-button (8) twice; the light 

indicator « » will light up.

Note:

 if you need to switch the coffee maker off 

during  the cappuccino making, press the button (6) 

«Cappuccino» again.
•  Remove the cup with the ready drink from the grid (2).

• 

After you finish using the coffee maker, switch the 

coffee maker off by setting the switch (11) «0/I» to the 

position «0».

• 

Wait until the coffee maker cools down, remove the 

filter holder (20) and wash the filter (21 or 22). 

•  If there is some milk left in the cappuccinator, remove 

the cappuccinator and put it in the fridge (pic. 12). If 

you used all the milk during the coffee making, it is 

recommended to remove and wash the cappuccinator 

(see the chapter «CAPPUCCINATOR CLEANING»).

MAKING LATTE

ATTENTION! When making latte be careful to avoid 

burns by outgoing hot steam.

•  Make sure that the removable tray (1) and the tray grid 

(2) are installed to their places.

•  Fill the tank (13) with cold water, do not exceed the 

maximal level mark, install the tank (13) back to its 

place.

•  Take the container (18), pull it towards yourself and 

remove it (pic. 1), remove the cappuccinator lid (16) 

from the container (18).

•  Fill the container (18) with milk, do not exceed the maximal 

level mark.

•  Install the cappuccinator lid (16) on the container (18) and 

install the cappuccinator back to its place until the lock 

clicking.

• 

Install one of the coffee filters (21 or 22) into the filter 

holder (20) matching the ledge on the filter (21 or 22) with 

the hole on the holder (20) and turn the filter (21 or 22) 

counter/clockwise.

• 

Add the required amount of ground coffee into the filter 

(21 or 22) with a measuring spoon (22) and slightly tamp 

the coffee in the filter (21 or 22) with the back side of the 

measuring spoon (23) (pic. 5, 6, 7).

• 

Install the filter holder (20) into the installation place «

» and turn the handle (4) to the right as far as it will go «

» (pic. 2, 3, 4).

•  Place a cup of suitable height and capacity on the grid (2) 

(see the table «CHOOSING THE APPROPRIATE CUP»).

•  Note: - During preliminary heating, you can warm up the 

cups that will be used for making coffee by placing them 

on the tray (6).

•  Direct the cappuccinator pipe (15) into the cup using 

the cappuccinator pipe angle adjustment bar (14), if 

necessary, change the length of the cappuccinator pipe 

(15) (fig. 9).

•  Turn the frothed milk supply (intensity) control knob (17) 

to the right (in this position it produces more frothed milk). 

Turn the frothed milk supply (intensity) control knob (17) to 

the left (in this position it produces less frothed milk) (pic. 

10, 11).