Krups EA 8050 Compact Espresseria - Инструкция по эксплуатации - Страница 10

8

If the above message

appears, remove, empty

and clean the drip tray.

The drip tray receives waste water and the coffee grounds collector receives used coffee grounds. The coffee cleaning tray
allows you to eliminate any deposits of coffee grounds above the percolation chamber.

Remove, empty and

clean the coffee

grounds collector.

The drip tray is equipped

with floats to tell you

when to empty it.

The warning message will remain displayed if the coffee grounds collector is not slotted in fully or not fitted correctly.

If the coffee grounds collector is fitted within less than 8 seconds, the appliance will ask you to confirm that you have

correctly emptied it. You cannot make espresso or coffee while the warning message is displayed. 

The coffee grounds collector has a maximum capacity of 12 coffees.

MAINTAINING YOUR APPLIANCE

As soon as you remove the coffee grounds collector, you will have to empty it completely to avoid any overflow.

Remove the coffee

cleaning tray.

Clean it under water

and dry thoroughly

before re-fitting.

EMPTYING THE COFFEE GROUNDS COLLECTOR, THE COFFEE CLEANING 

TRAY AND THE DRIP TRAY

RINSING OUT THE COFFEE CIRCUIT: SEE PAGE 5

MACHINE CLEANING PROGRAM – TOTAL DURATION: ABOUT 20 MINUTES 

You should perform the cleaning program about every 350 preparations of espresso or coffee.

The appliance will let you know when you need to proceed with cleaning through the ‘clean’ light coming on.

Caution! To benefit from the guarantee conditions, it is essential to perform the appliance cleaning cycle

when informed to do so. Be sure to follow the order of operations.

You can continue to use the appliance, but you are advised to perform the program as soon as possible.

To perform the cleaning program, you will need a recipient with minimum capacity of 0.6 litres and a KRUPS (XS 3000) cleaning tablet.

Press the

key to start the

automatic cleaning

program when the

“Cleaning needed”

message is dis-

played.

Just follow the

instructions

shown on the

screen.

The automatic cleaning program is in

three parts – the cleaning cycle itself,

then 2 rinsing cycles. This program

lasts about 20 minutes.

Press            to perform cleaning at

any time and then choose MAINTE-

NANCE => OK => CLEANING from

the menus displayed.

If you press the ‘On/Off’ key during cleaning or in the event of power failure, the cleaning program will start

again right from the beginning. You will not be able to postpone this operation. This is essential due to water

system rinsing reasons. In this case, you will need to use another cleaning tablet. Be sure to complete the entire

cleaning cycle to avoid any risk of irritation (seek medical advice if cleaning solutions are accidently swallowed).

The cleaning cycle is a continuous cycle and the pump can be heard intermittently. Do not put your hands under 

the coffee outlets during the cycle.

Only use KRUPS (XS3000) cleaning tablets. We cannot be held responsible for any damage that may result

from the use of tablets from other brands.

You can obtain cleaning tablets from KRUPS Service Centres.

Make certain to protect your work surface during cleaning cycles, especially if they are made of

marble, stone or wood.