Siemens TE501205RW - Инструкция по эксплуатации - Страница 23

19

en

Problem

Cause

Remedy

LED 

D

 flashes.

The water tank is not 

correctly installed or the 

filter is worn.

Correctly install the water tank�  

If the LED continues to flash, 

install a new filter and rinse, see 

chapter “Filter”�

Carbonated water in the 

water tank�

Fill the water tank with fresh tap 

water�

The coffee grounds are 

not compact and are too 

wet�

The grind setting is too 

fine or too coarse, or not 

enough ground coffee has 

been used�

Adjust the grinding unit to a 

coarser or finer setting, or use 

2 level measuring spoons of 

ground coffee�

LED 

I

 flashes.

Brewing unit  (5) is soiled�

Clean the brewing  unit (5)�

Too much pre-ground  

coffee in the 

brewing unit (5)�

Clean the brewing unit (5) Put in 

no more than 2 level measuring 

spoons of ground coffee�

The brewing unit 

 mechanism is stiff�

Remove and clean the brewing 

unit, see “Maintenance and daily 

cleaning”�

Brewing unit (5) is missing 

or has not been detected�

Switch off the appliance with the 

brewing unit (5) in place, wait 

three seconds and switch on the 

appliance again�

Coffee or milk froth quality 

varies widely� 

Build-up of limescale in the 

appliance�

Descale the appliance as 

described in the instructions�

Water dripped onto the 

inner floor of the appli

-

ance when the drip tray 

(8) was removed�

Drip tray (8) removed too 

soon�

Wait a few seconds after the 

last drink was dispensed before 

 removing the drip tray (8)�

The default settings have 

been changed and need 

to be reset�

Some settings have been 

made that are no longer 

required�

Press the power on/off button 

O / I

(9) to switch off the appliance� 

Press and hold the service button 

(12) and the steam button (11) 

and press the power on/off button 

O / I

 (9) to switch on the appliance� 

Then press the start button (10) to 

confirm. The default settings are 

reset�

LEDs 

 flash.

The appliance has a fault� Please contact the hotline�  

LEDs 

 flash.

Incorrect voltage�

Operate the appliance at 

220 V-240 V  only�

LEDs 

 flash.

The ambient temperature is 

too cold�

Operate the appliance at 

 temperatures  > 5° C�

If you are unable to solve the problem, please call the hotline. 

You will find the telephone numbers at the back of these instructions.