Siemens TE501205RW - Инструкция по эксплуатации - Страница 10

6

en

“Coffee strength” rotary knob

This rotary knob (13) is used 

to adjust the coffee strength 

or select the setting for pre-

ground coffee�

h

to

g

G

Very mild

Mild

Medium

Strong 

Ground coffee

“Drink selection” rotary knob

This rotary knob (14) is 

used to select the required 

beverage and quantity� It is 

also used to change user 

settings�

a

to 

c

Small espresso

Espresso

Small café crème

Café crème

Large café crème

b

to

d

2 small espresso

2 espresso

2 small café crèmes

2 café crèmes

2 large café crèmes

Milk frother

Pull the milk frother (6) out to open it and 

push it back in to close it�

Before using for 

the first time

General

Fill the appropriate container using only 

pure, cold, uncarbonated water and only 

roasted beans (preferably espresso or 

coffee bean blends for fully automatic coffee 

machines)� Do not use coffee beans that 

have been glazed, caramelised or treated 

with other additives containing sugar, since 

they will block the brewing unit� 

The water hardness setting can be adjusted 

on this appliance� The factory setting for the 

water hardness is 4� Check the hardness 

of the water you use with the enclosed test 

strip� If the test reveals a value other than 4, 

change the setting on the appliance accord-

ingly after switching on (see “Settings”, 

“Water hardness”)�

Setting up the appliance

1� 

Remove the protective film.

2�  Place the fully automatic espresso 

machine on a flat, water-resistant 

surface that can take its weight�  

The ventilation slots on the appliance 

must not be covered�

Important:

 Only use the appliance in 

frost-free rooms� If the appliance has been 

transported or stored at temperatures below 

0° C, wait at least 3 hours before operation�

3�  Pull out the mains plug from the cable 

compartment (20) and plug it in� Adjust 

the length of the cable by pushing it 

back in and pulling it out� To do this, 

place the appliance with its back flush 

with the edge of the work surface and 

either pull the cable 

downwards

 or 

push it 

upwards

�