Siemens TE501205RW - Инструкция по эксплуатации - Страница 19

15

en

Service programme

Duration: approx� 35 minutes

Depending on use, the service button (12) 

flashes at certain intervals.

The appliance should be cleaned and 

descaled immediately using the service 

programme� If the service programme is 

not run as instructed, the appliance may 

be damaged�

A

Caution!

Follow the instructions for using the 

descaling and cleaning agents for each 

service programme� Please observe the 

safety instructions on the packaging of the 

cleaning agent�

Never interrupt the service programme�  

Do not drink the liquids�

Never use vinegar, vinegar-based products, 

citric acid or citric acid-based products� 

Never put descaling tablets or other 

 descaling agents in the drawer (4)�

Specially developed and suitable 

 descaling and cleaning tablets are 

 available from retailers or customer 

service (see “Accessories”).

Important:

 If there is a water filter in the 

water tank (16), it must be removed before 

starting the service programme� Clean the 

brewing unit before starting the service 

programme, see chapter “Cleaning the 

brewing unit”�

To start the service programme, press and 

hold the service button (12) for at least 

5 seconds� 

Information:

 The service button (12) 

 flashes while the programme is running.

LED 

H

 lights up�

●

Empty the drip tray (8) and reinsert it�

The appliance rinses twice�

LED 

G

 lights up�

●

Open the drawer (4)�

●

Drop a Siemens cleaning tablet into 

the drawer (4) and close it�

●

Press the start button (10)�

LED 

D

 lights up�

●

Pour lukewarm water into the empty 

water tank (16) up to the 

0.5 l

 mark 

and then dissolve 1 Siemens descaling 

tablet TZ80002 in it� When using 

TZ60002, 2 tablets must be dissolved�

●

Press the start button (10)�

The service programme will now run for 

 approximately 10 minutes� 

LED 

F

 lights up�

●

Place a container with a capacity of at 

least 0�5 litres under the milk frother 

 outlet  (6)�

●

Pull out the milk frother (6)

to open it�

The service programme will now run for 

 approximately 12 minutes�

LED 

D

 lights up�

● Rinse the water tank (16) and refill it 

with fresh water up to the 

max

 mark�

●

Press the start button (10)�

The service programme will now run for 

approximately 30 seconds and rinse the 

appliance�

LED 

F

 lights up�

●

Push the milk frother (6) in to close it�

The service programme will now run for 

 approximately 8 minutes�

LED 

H

 lights up�

●

Empty the drip tray (8) and reinsert it�

If you are using a filter, reinsert it now. 

The appliance has been cleaned, descaled 

and is ready for use again�