Siemens TE501205RW - Инструкция по эксплуатации - Страница 12

8

en

3�  Turn the rotary  

knob (13) to position 

4�  Press and hold buttons 

B

 (11) and 

A

 (12) simultaneously for at least 

5 seconds� Either 

 “off” or 

 “on” 

lights up�

5�  Press the start button (10) to select “on”�

6�  Press and hold the start button (10) for 

at least 5 seconds to confirm. All of the 

LEDs light up briefly.

7�  LED 

D

 flashes and LED 

F

 lights up�

8�  Place a container with a capacity 

of 0�5 litres under the milk frother 

outlet (6)�

9�  Pull out the milk frother (6) to open it� 

LED 

F

 flashes.

10� 

Water will now flow through the filter and 

rinse it�

11� When LED 

F

 lights up constantly, 

press in the milk frother (6) to close it�

12� Empty the container� 

The appliance is ready to use again�

Information:

 Rinsing the filter  simultaneously 

activates the setting for the change filter 

display (= LED 

D

 flashes).

The filter is no longer effective when the 

change filter display appears, or at the 

latest after two months� It needs to be 

replaced for reasons of hygiene and so 

that there is no build-up of limescale (this 

could damage the appliance)� Replacement 

filters can be obtained from retailers or from 

customer service (see “Accessories”)� If no 

new filter is inserted, change the setting for 

the filter (see “Water hardness”).

Information:

 You can use the filter indicator 

to mark the month in which you inserted the 

filter. You can also mark the month in which 

you will need to replace the filter next 

(at the latest after two months)�

Information:

 If the appliance has not been 

used for a prolonged period (for example, 

when you are on vacation), the existing filter 

should be rinsed before the appliance is 

used again� To do so, dispense a cup of hot 

water and pour it away�

Settings

You can customize the settings on the 

appliance�

You can make the following adjustments:

Water hardness

The water hardness setting can be adjusted 

on this appliance� It is important to set 

the water hardness correctly so that the 

 appliance can accurately indicate when it is 

time to run the descale process� The factory 

setting for the water hardness is 4� You can 

establish the water hardness either by using 

the test strip provided or by asking your local  

water provider�

Dip the test strip in the water briefly, shake 

it gently and check the result after one 

minute�

Level Water hardness

German (°dH) French (°fH)

1

2

3

4

1-7

8-14

15-21

22-30

1-13

14-25

26-38

39-54

If you wish to change the default degree of 

water hardness, or if you have inserted a 

water filter, proceed as follows: